Lee Precision, Inc.
P65Warnings.ca.gov
Instructions for LEE models including: BF2400 Inline Bullet Feed Die, BF2400, Inline Bullet Feed Die, Bullet Feed Die, Feed Die, Die
Lee Precision, Inc.. Instructions
File Info : application/pdf, 2 Pages, 128.26KB
DocumentDocument22 CAL. INLINE BULLET FEED BF2400 Bullet Feed Sleeve Bullet Feed Cap BF5385 Sleeve Return Spring BF5377 Rifle Bullet Feed Body 6mm Detent Balls (qty. 2) SETUP INSTRUCTIONS: # 92002 "A" 1. Measure projectile's cylindrical portion, "A" section. Refer to the bullet length chart (see reverse) to confirm the two detent balls are installed in correct holes of bullet feed sleeve. Detent balls are installed in upper holes from factory. 2. Thread die into the press a couple of turns. 3. Place a flared case into shell plate. 4. Fill the bullet feed sleeve with bullets, base down, with one protruding. 5. Raise case to top of stroke. Screw die clockwise until the bullet stack drops plus an additional ½ turn. 6. Finger tighten lock ring, tighten split clamp with 3/32" hex key. TIPS FOR SUCCESS: 1 Change ball position over a tray or container to prevent losing balls. (Replacements #92002) 2 Keep bullet stack near the top of the sleeve, weight of bullets aids in seating a bullet into the case. 3 Adequate case mouth flare is required to reduce bullet tipping. 4275 COUNTY ROAD U HARTFORD WI 53027 www.leeprecision.com Inline Bullet Feed 22 Cal.(22 Hornet to 222 Rem Mag) 7 34307 91998 6 INLINE BULLET FEED DIE Bullet Length Chart *Provides a starting point, bullet profile will factor into correct hole selection. Maximum Cylindrical Length "A" *Do not include boat tail or ogive profile. A= .390" or shorter Lower Holes A= .390" to .590" Upper Holes Troubleshooting Symptom Solution No bullets feed, but sleeve returns to home position. Die must be screwed into press further. Multiple bullets feed, or one feeds Bullet is too short for hole selected, but sleeve does not fully return to move balls to lower hole. home position. No bullets feed and sleeve does Bullet is too long for the hole being not fully return to home position. utilized, move balls to higher hole. For the ultimate in convenience, order the gatling style magazine feed. # 92014 If loading lower quantities, consider the single tube adapter. # 92024 Replacement balls # 92022 WARNING: This product may contain steel alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. For more information, go to www.P65Warnings.ca.gov. To prevent exposure, do not alter the product by welding, grinding, etc. LEE PRECISION, INC. ©2023 PRINTED IN USA 4275 COUNTY ROAD U · HARTFORD WI 53027 www.leeprecision.com