User Manual for SNAP TRIM models including: STBD01, Aero-Flex Snap and Trim BD Cartridge Upgrade Kit, BD Cartridge Upgrade Kit, Aero-Flex Snap and Trim, Aero-Flex Snap
SNAP & TRIM STBD01 858460002146 0858460002146 1007697739
STRING SPOOL UPGRADE for battery string trimmers Easy No-Tools Conversion: · Remove original cap and spool · Load two Aero-Sharp® Line Blades over cap posts, under retainer hoods, and into slots · Always run with 2 cutters for proper balance · Use only Aero-Flex cutters specially designed for this product · Install Snap & TrimTM assembly into open receiver head windows · Cap must be properly aligned to fully close · Align cap guide with old string outlet boss. (Installs only one way with cap guide over string outlet boss) · Assure both cap fingers are fully seated and engaged before operation. 1 2 50' 15m Operate · Be sure to operate with trimmer's grass shield in place · Wear protective eyewear, keep bystanders away. · Rest trimmer's Glider on grass; cut through grass while moving the trimmer in any direc- tion. · The cut height is preset, tilt the trimmer on the glider for lower cutting height. Prevent Motor Burn-out · Slowly feed trimmer into the cut, very gently to avoid overloading the motor. · Rapid cutting or plunging the cutters into heavy vegetation will risk motor burn-out. · The Glider must not be removed from the trimmer as lower cuts to the ground will increase operating watts to further risk motor burn-out.Adobe PDF Library 9.9 Adobe InDesign CS5 (7.0)