BAUHN 2.1 Channel Soundbar with Built-In Subwoofer

Welcome

Congratulations on your purchase! This manual provides all the information needed to use your new BAUHN® product. Please pay close attention to safety and usage information marked with the ! symbol. BAUHN® products meet high standards of performance and safety, backed by a 1 Year Warranty. This product is intended for indoor domestic use only and should not be used for commercial, industrial, or outdoor purposes, or for anything other than its intended use as described in this manual. We hope you enjoy your purchase for many years.

Unpack and Prepare

What's in the Box

Before setting up your new Soundbar, check you have everything:

• A. 2.1 Channel Soundbar
• B. Remote Control
• C. AAA Activ Energy Batteries (2)
• D. 3.5mm Audio Cable
• E. Optical Cable
• F. Wall Mount Installation Kit
• G. Power Adaptor
• H. User Manual
• I. Warranty Certificate
• J. Quick Start Guide
• K. General Safety Warnings

You will need:

• Phillips-head screwdriver and a drill (for wall mount installation)
• HDMI Cable, if you want to set up and use HDMI CEC. (Otherwise, use the included optical cable if you don't use HDMI.)

Wall Mount Installation Kit

The illustration below shows the contents of the wall mount installation kit:

• A. Plastic Anchors (2)
• B. Long Screws (2)

Important Notes:

• Place the Soundbar on a level surface.
• Place the Soundbar away from any source that may generate heat or vibrations.
• Ensure adequate space around the Soundbar for airflow.
• The remote control works up to 6 metres away from the Soundbar.
• Unplug the Soundbar before cleaning. Clean with a dry cloth only; do not use water or chemicals.
• Use only the provided power supply.
• Keep liquids, children, and pets away from the Soundbar at all times.

Installation

This soundbar can be placed free-standing on a surface or mounted to a wall.

Free-standing

Place the soundbar on a secure, flat surface. Ensure the soundbar rests on its rubber pads (on the left and right sides of the bottom) and no other part of the bottom touches the surface.

Wall mounted

Wall-mounting instructions are provided on the following pages.

Important Safety Information for Wall Mounting:

• Wall-mounted installation must be carried out by qualified personnel only. Incorrect assembly can result in severe personal injury and property damage. If installing yourself, check for hidden electrical wiring and plumbing.
• The installer is responsible for verifying that the wall can safely support the total load of the soundbar and wall brackets.
• Additional tools (not included) are required for installation.
• Do not overtighten screws.
• Use an electronic stud finder to check the wall type before drilling and mounting.

Wall Mounting Instructions

1. Use a pencil to mark drill hole locations for the anchors. Ensure the marks are level before drilling. Use a 6mm bit and power drill (not supplied) to drill holes on the marks.
2. Insert plastic anchors into the holes and push until flush with the wall. Drive screws into the plastic anchors and tighten until the screw head is approximately 3mm from the wall.
3. Slide the soundbar onto the screws fixed to the wall. Ensure the soundbar is secure and firmly attached to the wall.

Connect to Power

! Make sure the soundbar is switched off at the power outlet until all cables are connected.

Don't forget to plug in the soundbar to the power outlet. Leave the power switched off until installation is finished.

Controls and Connections

Get to know your Soundbar

Front:

The LED display on the soundbar will turn off automatically after 5 minutes of no operation.

Buttons on the Soundbar (Right side)

1. -: Decrease the volume level.
2. U/ (Power button/Mode): Press to turn on. Press to select your preferred input source. Press and hold to put in Standby mode.
3. +: Increase the volume level.

See the next page for more information on connections.

Rear Ports on the Soundbar