Columbia Lighting | Current - HLI Brands
Columbia Lighting | Current - HLI BrandsLED Commercial Lighting and Lighting Controls | Current - HLI Brands
Instruction Manual for Columbia LIGHTING models including: CFP Series, CFP14-4035, Edge-LIT Flat Panel, CFP Series CFP14-4035 Edge-LIT Flat Panel
CFP Series, Edge-Lit Flat Panel, 2x4, Color Temperature: 3500 K, | Crescent Electric Supply Company
CFP Series, Edge-Lit Flat Panel, 2x4, Color Temperature: 4000 K, | Crescent Electric Supply Company
CFP Series, Edge-Lit Flat Panel, 2x2, Color Temperature: 3500 K, | Crescent Electric Supply Company
File Info : application/pdf, 2 Pages, 1.26MB
DocumentDocumentCFP Instruction Manual CFP EDGE-LIT FLAT PANEL NOTE: Components shown in images are representative only and may vary based on the configuration ordered. CAUTION Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. WARNING If any special control devices are used with this luminaire, follow the instructions carefully to assure full compliance with NEC requirements. If there are any questions, contact a qualified electrical contractor. WARNING This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product. INSTALLATION METHOD 1: RECESSED MOUNTING STEP 1 Raise unit into ceiling. Cross tees may need to be trimmed when fixtures are installed in certain applications. For instance when installing a 2x4 recessed troffer into a 2x2 ceiling grid the cross tees would need to be trimmed or a zero clearance cross tee utilized. STEP 2 Bend T-bar clips into position. INSTALLATION METHOD 2: LUMINAIRE FITTING *The luminaire fitting models are CFPSMK14 / CFPSMK22 / CFPSMK24 STEP 1 Snap corner bracket to extruded rails, making sure that mounting flanges are on opposite sides. STEP 2 Attach frame to ceiling structure. STEP 3 Remove one non-mounting frame side and slide in flat-panel. Make all electrical connections using appropriate fittings. STEP 4 Reinstall frame side to complete. Page 1/2 Rev. 12/20/21 COL-CFP-ins © 2021 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice. 701 Millennium Blvd · Greenville, SC 29607 / Tel 864.678.1000 / Website www.columbialighting.com CFP EDGE-LIT FLAT PANEL WIRING CONNECTION *Wiring connection of both installation methods are the same STEP 1 Open access plate. Use knockouts to connect power access using appropriately-sized electrical fittings. CFP Instruction Manual STEP 2 Make wiring connections. LUMEN SELECTABLE INSTRUCTIONS DIfferent lumen levels can be achieved by setting the switch on the driver cover to different positions. For 38W Product 2800/3300/4000 Lumens For 52W Product 3400/4100/5500 Lumens Page 2/2 Rev. 12/20/21 COL-CFP-ins © 2021 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice. 701 Millennium Blvd · Greenville, SC 29607 / Tel 864.678.1000 / Website www.columbialighting.com