SoluM SmartTag+ CS06FHB01 Quick Start Guide
Model: CS06FHB01
Product Name: SoluM SmartTag+
Getting Started
Important: Please visit www.mysolum.com to view device information, the full user manual, and detailed usage precautions before using the product.
Your consumer rights are governed by the law of the country in which you purchased the product. Please contact your service provider for more information.
To connect a SmartTag to a mobile device:
- Press the button (a) to activate the SmartTag.
- Follow the on-screen instructions to complete the connection.
If the pop-up window does not appear, use a mobile device to scan the QR code on the box.
Safety Precautions
- Do not use your SmartTag in a hot environment or near a fire.
- Battery Warning: Do not swallow or disassemble any battery. Chemical burn hazard. If the battery from your SmartTag is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep batteries away from infants and children. If the battery compartment does not close securely, stop using the product and keep it away from infants and children. If you think batteries might have been swallowed or inserted inside any part of the body, seek immediate medical attention.
- Risk of fire or explosion if the battery is replaced by an incorrect type.
FCC Information
FCC Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment. The FCC ID is affixed on the rear device case.
CALIFORNIA USA ONLY
This Perchlorate warning applies only to primary CR(Manganese Dioxide) Lithium coin cells in the product sold or distributed ONLY in California USA. "Perchlorate Material-special handling may apply, see www.dtsc.ca.gov/hazardouswaste/perchlorate"
FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
IMPORTANT NOTE: FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
