User Manual: Milk Frother

Introduction

This user manual provides essential information for operating and maintaining your George Wilkinson Milk Frother (Model EK6146).

Description of Parts

• 1. Lid
• 2. Sealing ring
• 3. Handle
• 4. Milk frother cup
• 5. Whisk spindle
• 6. Removable whisk
• 7. On/off switch ([power-button])
• 8. Milk frother base unit
• 9. Max. heating fill mark (300 ml)
• 10. Max. frothing fill mark (150 ml)
• 11. Min. fill mark (80 ml)
• 12. Indicator lights

Safety Instructions

Always follow basic safety precautions when using electrical appliances:

• Ensure the appliance's voltage matches your local power supply.
• This appliance can be used by children aged 8+ and persons with reduced capabilities if supervised and they understand the risks.
• Keep children away from the appliance, especially when in use or cooling down.
• Do not allow children to play with or clean/maintain the appliance unsupervised.
• This appliance is not a toy.
• Discontinue use immediately if the cord, plug, or any part is damaged or malfunctioning to prevent injury.
• Repairs should only be carried out by qualified electricians.
• Keep the appliance and cord away from heat sources, sharp edges, and hot surfaces.
• Do not immerse electrical components in water or other liquids.
• Do not operate with wet hands or wet connections.
• Do not leave the appliance unattended while plugged in.
• Unplug by switching off and pulling the plug by hand, not by the cord.
• Do not pull or carry the appliance by its power cord.
• Use only for its intended purpose and with supplied accessories.
• Do not use outdoors.
• Do not store in direct sunlight or high humidity.
• Do not move the appliance while in use.
• If dropped in water, unplug immediately and do not reach into the water.
• Always unplug and allow to cool before cleaning, maintenance, or storage.
• Use on a stable, heat-resistant surface at a comfortable height.
• Do not operate with external timers or remote controls.
• Extension cords are not recommended.
• Intended for domestic use only.

CAUTION: Hot surface – do not touch hot sections or heating components.

WARNING: Boiling water and steam can cause serious injury; exercise extreme caution.

Dos and Don'ts

DO:

• Ensure the milk frother base is clean before each cycle.
• Always fill the milk frother cup above the minimum fill mark.

DON'T:

• Connect to power before adding milk.
• Allow liquid to contact the base.
• Exceed the maximum fill mark.
• Operate the milk frother when empty.

Boil-Dry Protection

If milk level is insufficient, indicator lights will flash and the appliance will shut off automatically. If this occurs, switch off, unplug, and allow to cool for at least 10 minutes before re-use.

Care and Maintenance

Switch off, unplug, and allow the appliance to cool completely before cleaning or maintenance.

1. Wipe the milk frother with a soft, damp cloth and dry thoroughly.
2. Clean the interior with warm, soapy water, then rinse and dry thoroughly.

Do not use harsh or abrasive cleaners or scouring pads, as this may cause damage.

NOTE: The milk frother should be cleaned after each use.

WARNING: The milk frother is not dishwasher safe.

Instructions for Use

Before first use

Clean the milk frother as described in the 'Care and Maintenance' section.

Using the milk frother

1. Place the base unit on a flat, stable, heat-resistant surface at a comfortable height.
2. Position the removable whisk onto the whisk spindle at the bottom of the milk frother cup.
3. Fill the cup with milk, ensuring it is above the minimum fill mark but below the maximum frothing fill mark.
4. Attach the lid, place the frother onto the base unit, plug it in, and switch it on.
5. Press and hold the [power-button] to switch on; the indicator light will illuminate.
6. Press the [power-button] repeatedly to change the function. The frother will turn off automatically when the cycle is complete.
7. Switch off and unplug the appliance. Carefully remove the lid and pour out the milk.

Making hot chocolate

1. Place the base unit on a flat, stable, heat-resistant surface at a comfortable height.
2. Position the removable whisk onto the whisk spindle at the bottom of the milk frother cup.
3. Pour milk into the cup up to the maximum fill mark.
4. Add a maximum of 35g of chocolate shavings per 300ml of milk.
5. Press and hold the [power-button] to switch on, then press it three times to start the program.

Frothing Functions

Storage

Ensure the milk frother is cool, clean, and dry before storing in a cool, dry place. Do not wrap the cord tightly; wrap it loosely to prevent damage.

Specifications

Product code: EK6146

Input: 220-240 V ~ 50/60 Hz

Output: 500 W

Disposal Information

This symbol indicates that the product and its batteries should not be disposed of with household waste. It is the user's responsibility to recycle them properly to conserve natural resources and prevent negative environmental and health impacts. Contact local authorities or retailers for disposal information.