Instruction Manual for Swiss Madison models including: SM-ST030 Power Flush Tankless, SM-ST030, Power Flush Tankless, Flush Tankless
17 hours ago — Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for ...
5 часов назад — The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable ...
5 часов назад — Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for ...
File Info : application/pdf, 10 Pages, 4.51MB
DocumentDocumentTankless Toilet INSTALLATION INSTRUCTIONS well made forever www.swissmadison.com | 1-434-623-4766 | info@swissmadison.com @SwissMadison #WellMadeForever TANKLESS TOILET INSTALLATION PRIOR TO INSTALLATION: · Inspect toilet to ensure no damages have occurred while in shipping. · Observe all plumbing and building codes in accordance with your state and local requirements. · All dimensions are nominal! Be sure to measure your toilet prior to installation. · The step-by-step guidelines in the installation instructions are a general reference. Should there be any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss Madison products by hiring a licensed professional. · Read installation and maintenance instructions thoroughly before installing. Be sure to use proper tools and always wear proper personal safety accessories for your protection. · Two people are recommended to handle and install this product as it is fragile. QUESTIONS OR CONCERNS? Please contact us: 1-434-623-4766 info@swissmadison.com INCLUDED PARTS: Tankless Toilet Sealing Flange Floor Anchor Kit SUGGESTED TOOLS & MATERIALS: Safety Glasses Caulk Tape Measure Wrench Pencil Drill TANKLESS TOILET Top cover Rear cover decorative sheet Rear cover Flush button Ceramic body INSTALLATION Rear cover trim strip Seat INSTALLATION PREPARATIONS: · Make sure that the floor tiles and the wall tiles have been paved, and that a pit tube and a water supply pipe are reserved. · Reserve the installation position according to the dimensions given in the figure below (symbols * refer to the recommended dimensions) to ensure normal use of the water supply pipe. · Make sure the distance between center of the pit tube and the wall, i.e., the pit distance, matches with the product. · Turn on the water supply switch to drain water to flush away the mud and other foreign matters in the reserved water pipes to avoid blockage of the water pipes.. * 9.8 Angle valve * 9.8 0.2 ~ 0.4 Pit distance Drain outlet * 47.2 Ø 4.3 * 19.7 * 19.7 TANKLESS TOILET INSTALLATION: 1 · The minimum dynamic working water 2 pressure is 15 PSI. After running your water for 10 seconds, 0.502 gallons (1.9 L) should be accounted for. 10s INSTALLATION 3a 3b 0in Pit distance: 12 0in Pit distance: 15.7 Make sure the product is installed in a proper position from the wall so that it can be repaired or replaced easily in future whenever necessary. TANKLESS TOILET 4 5 INSTALLATION 6 7 Filter 1 2 TANKLESS TOILET 8 9 INSTALLATION 10 11 TANKLESS TOILET TEST BEFORE USING 1 1 2 2 INSTALLATION Open the tee and press the flush button to test for any leakage. After installation, make the product stand for 24 hours before use. TANKLESS TOILET OPERATION OPERATION KNOB FUNCTION SYMBOL OPERATION Flushing Press the flush button . INSTALLATION REMARKS / CLEANING & MAINTENANCE FILTER CLEANING The filter needs to be cleaned at regular intervals. If the product fails in water supply, has a water supply pressure smaller than ordinary time or cannot work normally, please clean the filter first. 2 Filter In cleaning, make sure the water supply switch is off; after cleaning, mount the filter back and inspect and make sure there's no water leakage. SURFACE CLEANING Use a smooth sponge or a piece of soft cloth dipped with a proper amount of room temperature water or neutral detergent and then wrung out to wipe the product surface. When cleaning any other part of the product, lift the top cover and the seat. Do not lay down the to cover or the seat until the detergent in the product has been completely flushed away, otherwise the evaporated detergent may corrode the product surface. WINTERIZATION When in use, make sure the indoor temperature is not below 4°C (39.2°F). When the indoor temperature is below 4°C (39.2°F), stop using the product and operate as below. - Turn off the angle valve to stop water supply. After that, drain the water in the tank to flush the product once. If the product is maintained before drainage, the product may damage and leak. If the product is moved from a cold place to a warm place, the water in it will condensate. In this case, make the product stand for a couple of hours before use. TANKLESS TOILET INSTALLATION TROUBLE SHOOTING If it is believed in that the product has a fault, eliminate the fault as below. If the product cannot work normally after that, please contact the local repair center or reach us through our service hotline. FAULT CAUSE PHENOMENON ANALYSIS SOLUTION Water leakage Loose hose connector Turn off the water supply switch and check whether the connector between it (or the product) and the hose is tightened. Flushing failure Abnormal water supply Insufficient flushing force Too low water supply pressure Insufficient water in the tank Check whether the water supply switch is on and whether the filter is blocked. Please make sure the water supply pressure is above 0.1MPa (15PSI). Please make sure the interval between each twice flushing is longer than 60s. WARNINGS · When moving the product from a cold or humid environment to room temperature, please wait two hours until the condensed water is completely volatilized to prevent electrical short-circuiting. · Do not place or store product where it can fall or be pulled into a tub or sink. · Do not reach for an item that has fallen into the water. · Heavy impact on ceramic leads to damage and water leakage. · Never embed toilet base into cement, mortar or similar substances, this can lead to expansion cracking. · Do not stand on seat, bowl or toilet lid. · Do not use varnish thinners, gasoline, liquid chemicals, detergents, insecticides, toilet cleaners or scrubbing brushes, it may damage the product. · Only use tap water or potable water to prevent chafing. · Exposure to direct sunlight is not recommended. · This product is equipped with a soft-close seat. Heavy pressing may damage the soft-close hinges. · Do not lean against the toilet seat lid to avoid damage. · Do not try flushing diapers, sanitary napkins or other unintended items to prevent clogging. · If this product is malfunctioning, stop using immediately, turn off water supply, and contact Swiss Madison customer service. · Before installation, disassembly, repair or maintenance, unplug the power and turn off water supply. · Do not use in an environment below 32°F. · This product is not intended for children without adult supervision. · This product is not intended for individuals with reduced physical, sensory, or mental capabilities. · To prevent damage cause by freezing, please take measures to increase the temperature of the toilet. 1-434-MADISON(623-4766) | www.swissmadison.com ONE YEAR LIMITED WARRANTY Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our customers with beautiful, durable, long-lasting products. Should there be any defects in materials or craftsmanship under regular use that are discovered within the first year of installation, Swiss Madison® will provide replacement parts at no charge, or at its discretion, replace any product or part of the product that is deemed defective, under normal installation, use, service or maintenance. This warranty applies only to the original purchaser. Proof of purchase will be required in the instance of a claim. Swiss Madison® recommends all installations of Swiss Madison® products to be conducted by a licensed, professional plumber or contractor. Swiss Madison® will not be held responsible for any damage or product failure due to improper installation, misuse, or failure to utilize a licensed professional for installation. Swiss Madison® is not responsible for any installation or removal costs. THIS ONE YEAR LIMITED WARRANTY WILL BE VOIDED IF: · The installation recommendations were not followed by the installer · The product has been moved from its initial place of installation · The product has in any way been modified from its packaged state · The product has been subjected to improper maintenance, abuse, misuse, excessive use of chemicals, accidents, or other damages, etc. Swiss Madison® makes no implication that its products comply with any local building or plumbing codes. It is the consumer's responsibility and obligation to determine local code compliance prior to and during installation. This warranty extends only to the original purchaser and first consumer. Swiss Madison® is not responsible for any special, incidental or consequential damages associated with the installation, replacement, return or use of the original purchaser's product. This includes, but is not limited to: freight costs, labor, travel time, lost profit, home damages and other contingent liabilities and costs (including, without limitation, costs associated with `professionals' or `experts', investigations, audits, analyses, attorneys and any other professional/hired services). The Swiss Madison® warranty is a comprehensive and explicit limit of liability. All items not disclosed within the warranty are not addressable within the responsibility of Swiss Madison®. Certain states have variances regarding implied warranties; in those situations, we remain fully compliant. QUESTIONS OR CONCERNS? Please contact us directly at 1-434-MADISON (623-4766) WARNING: Contents of your order may contain sharp and possibly other harmful pieces and may cause hazard to children and adults. Swiss Madison® is not responsible in any way for personal damages.