Cycplus C3 pedálfordulatszám- és sebességérzékelő kompatibilis: Wahoo, Zwift, Endomondo, Mapmyride stb.
Speed/Cadence Sensor C3 User Guide Quick Sta 01 Push the batte cover's protrusion to the center position and then open the batte cover. 03 Install the batte cover onto the body. When installing the batte cover, make sure to align the protrusion to the center position. Speed 04 Press the batte cover tightly, and then push the batte cover's protrusion to the left or right to set the sensor to speed or cadence mode. Cadence Fix to Bicycle Speed 02 Remove the batte isolation sheet and then reinstall the batte cover. Fix the cu ed rubber pad onto the bottom of the sencor Cadence Fix the at rubber pad onto the bottom of the sencor Instructions for Use 1. Before using, please open the batte cover, and remove the transparent insulation spacer. 2. One sensor cannot measure both speed and cadence simultaneously. If you need to measure both, please purchase two sensors. 3. For speed measurement, the hub width must be more than 38mm. 4. The product defaults to cadence measurement. The Bluetooth name is CYCPLUS S3 when used for speed measurement. 5. When using Bluetooth protocol, it can only be connected to one device or app at a time. To change the device or app, please disconnect the previous one rst. 6. When using the ANT+ protocol, it can be connected to multiple devices simultaneously. 7. When using a sma phone app, search for the sensor in the app. Searching via phone Bluetooth is invalid. 05 After installation, the indictor light will ashes for 10 seconds. BlueSpeed GreenCadence RedLow batte Fix the sensor onto the hub using a rubber band. Turn the wheel to activate the sensor and establish a connection with your device or app. Fix the sensor onto the crank using a rubber band. Turn the crank to activate the sensor and establish a connection with your device or app. Speci cations Dimension: 9.5mm×29.5mm×38.0mm Weight: 9.2g Batte : 220mAh CR2032 Usage time: 600 hoursCadence/ 400 hoursSpeed Standby time: 300 days Protection rating: IP67 Compatible with: Garmin, Wahoo, Zwift, Tacx, BLjton, XOSS, Blackbird, and other devices Protocol standards: The sensor can connect to any APPs or devices that suppo Bluetooth or Ant+. Summa Switch the work modes Speed mode Open the batte cover Cadence mode When switching modes by turning the battery cover, please hold the cover with your hand to prevent it from popping up when passing through the gap in the middle. Indicator Light Blue light ash Speed measurement Green light ash Cadence measurement Red light ash Batte power is less than 20% Facto Info Manufacturer: Chengdu Chendian Intelligent Technology Co., Ltd Warranty: One-year free replacement or repair After sale E-mail: steven@cycplus.com MADE IN CHINACorel PDF Engine Version 22.0.0.412