User Manual for REDRAGON models including: BK-7111, BK-7111 Scissors Mechanism Slim Wireless Keyboard, Scissors Mechanism Slim Wireless Keyboard, Mechanism Slim Wireless Keyboard, Slim Wireless Keyboard, Wireless Keyboard, Keyboard
Eastern Times Technology Co., Ltd. ET-7114A REDRAGON SCISSORS MECHANISM SLIM WIRELESS KEYBOARD, REDRAGON SCISSOR MECHANISM SLIM WIRELESS KEYBOARD TUVET-7114A TUVET7114A et 7114a
1
FAQ
1. If the keyboard doesn't respond, please check if the keyboards USB cable is correctly inserted into the corresponding USB port on the computer, or try another USB port on the computer.
2. If you spill liquid on the keyboard, please unplug the keyboards USB cable from the computer immediately. Wipe off excess liquid and put the keyboard in a dry and ventilated place. Make sure the keyboard is dried naturally before the next use.
5
I. Selection of working mode
1. 2.4G mode: In keyboard mode, turn the power switch to the 2.4G position, the " " LED on the keyboard will slowly flash green. Insert the receiver into a valid USB port on the computer, and the " " LED on the keyboard will be normally on in green and be off in about 3 seconds. If the keyboards needs to be paired with the receiver again, hold FN+ "4" key for about 3 seconds, and the " " LED on the keyboard will rapidly flash green, and you can insert or replace the receiver on the USB port, and the pairing will be successful.
2.Bluetooth mode: In keyboard mode, turn the power switch to the BT position. Hold the "FN+1/2/3" key on the keyboard for about 3 seconds, and the keyboard will enter the pairing mode of Bluetooth channel 1/Bluetooth channel 2/Bluetooth channel 3. The " " LED on the keyboard will flash rapidly in blue/cyan/purple, and the keyboard will broadcast externally simultaneously: BT5.0 KEYBOARD and BT3.0 KEYBOARD devices. Depending on the terminal device that needs to be paired, follow the corresponding steps to pair with the keyboard. When the pairing is successful, the " " LED on the keyboard will be normally on in blue/cyan/purple and be off in about 3 seconds. When switching between the three paired 3 Bluetooth channels is required, just press the FN+1/2/3 key to switch between them.
II. Low battery indication/working current
Low battery indication: When the keyboard is in 2.4G or BT working mode, if the built-in battery of the keyboard is low, the " " LED will flash slowly in red, reminding you to replace the battery.
2
BATTERY SAFETY GUIDELINES DO NOT replace the battery with a different model. DO NOT use this product if the battery shows signs of damage including, but not limited to tearing, deformation, leakage, or the smell of electrolytic material. DO NOT touch the battery if material is leaking and seek immediate medical attention if any material comes into contact with your skin or eyes. DO NOT expose the battery to liquid, heat sources, electricity (outside of the product itself ), or other non-standard operating condition. DO NOT remove the battery except for proper disposal and recycling as required by local laws and regulations. DO NOT impact, bend, alter, dissemble, or otherwise damage the battery as the contents are volatile, hazardous, and can be harmful.
CAUTION: Failing to follow all safety guidelines may result product damage, explosion, fire, and/or electric shock.
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
6
III. Automatic hibernation/wake-up/manual power-off functions
When the keyboard is in 2.4G or BT working mode, if it is not used for about 3 minutes, it will enter a power-saving state, and it will be waken up for use again by pressing any key. If you carry the keyboard out or do not use it for a long time, please turn the power switch of the keyboard to the OFF position.
IV. Functional description of other keys
1) When the system switch is turned to WIN (the following key function categories apply
to the WIN system),
The
+ key can lock and unlock the WIN key to prevent accidental triggering option
of the key during gaming
FN+F1= Decrease screen brightness
FN+F2= Increase screen brightness
FN+F3= Display multi-task window(Alt+Tab)
FN+F4= Desktop Win+D
FN+F5= Return
FN+F6= Search
FN+F7= Previous title
FN+F8= Play/pause
FN+F9= Next title
FN+F10= Mute
FN+F11= Decrease volume
FN+F12= Increase volume
3
2) When the bottom system switch is turned to MAC (the following key function categories apply to the MAC system), F1= Decrease screen brightness/FN+F1=F1 F2= Increase screen brightness/FN+F2=F2 F3= Display multi-task window/FN+F3=F3 F4= Call out Siri /FN+F4=F4 F5=app exposé function/FN+F5=F5 F6= Search/FN+F6=F6 F7= Previous title/FN+F7=F7 F8= Pause/FN+F8=F8 F9= Next title/FN+F9=F9 F10= Mute/FN+F10=F10 F11= Decrease volume/FN+F11=F11 F12= Increase volume/FN+F12=F12
3) FN+<[{>=Scrlk ; FN+<]}>=Pause ; FN1+<;:>=HOME;FN+<'">=END;FN+P=PrtSc FN+W: Exchange positions of English letters A/W/S/D and four direction keys / / / in turn.
V. Description of indicator light status
" " and " " NUM/CAPS-LED indication function When NUM /CAPS ON is activated the corresponding LED will be normally on in red " " ---Working mode 2.4G mode/BT mode and low battery indication " " ---Charging indication
4
BK-7111REDRAGON SCISSORS MECHANISM SLIM WIRELESS KEYBOARD
7
BK-7111/ET-7111
2024-7-10
User manual
A.1
Adobe PDF library 16.03