2-IN-1 Wireless Charger

Products

This product is a two-in-one wireless charger, featuring a smart chip that supports simultaneous charging for cell phones and smartwatches. It offers high efficiency and stable performance, providing instant charging and an easy wireless charging experience. It can also wirelessly charge other electronic devices that support the Qi standard.

Product Parameters

Support Devices

• Mobile phone wireless charging module is compatible with iPhone 8 to iPhone 14 series cell phones and other cell phones and devices that support Qi wireless charging protocol.
• Watch wireless charging module is compatible with Apple Watch 2 to 8 generation, SE watches, and other series models wireless charging.

(Note: The greater the distance from the center point, the worse the charging effect.)

Operating Instructions

1. Using the cable provided, connect the 2-in-1 Wireless Charger to a reliable wall adapter.
2. Charging a Qi-Compatible Phone: Place your smartphone on top of the phone charging area to begin charging.
3. Charging a Watch: Place your Apple watch atop of the watching charging area to begin charging. It's recommended that the watch charger either be flat angle for optimal charging.
4. Charging any other Qi-compatible device: Place your Qi compatible device atop of the phone charging area to begin charging.

Important Safety Instructions

When using this product, basic precautions should be followed, including but not limited to the following:

1. Read and review the instructions manual before operating the 2-in-1 wireless charger.
2. Use only power adapters that are certified and tested to charge this item.
3. We strongly recommend using a high quality, certified wall adapter to provide power to this device. Failure to do so may result in slow charging speeds or product failure.
4. Avoid placing metal or magnetic items on the charging area which could result in overheating and product failure.
5. To reduce the risk of injury, close supervision is necessary when the product is used by children.
6. Do not expose the power bank to extreme weather (rain, snow, excessive heat).
7. Do not disassemble the product or replace any parts. In case of damage to this item, please stop using the product immediately.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not explicitly approved by the party responsible for compliance could void the user's authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.

Compliance: CE, FC, ROHS