1. Scope
1.1 This work instruction applies to personnel performing OmniStand packaging.
2. References
2.1 None.
3. Forms
3.1 None.
4. Materials
4.1 If packing is needed, ensure all necessary materials are included:
- A005-509 OmniStand™ Balance System (Item 1).
- Base cardboard packaging (Item 2).
- Short packaging columns (2 total) (Item 3).
- Long packaging columns (3 total) (Item 4).
- Rail cover packaging (Item 5).
- Top packaging dust cover (Item 6).
- Asset Tag Label (Item 7). Ensure serial on tag matches device serial.
- User Manual (PN 51510).
- Label LBL 0256 (6 total) (Item 9).
4.2 Packaging Procedure:
- Place the OmniStand™ Balance System (Item 1) into the base cardboard packaging (Item 2). This step may require a two-person lift. Ensure the unit's wheels are in the "locked" position.
- Cover the OmniStand™ unit with a plastic polybag.
- Place the rail cover packaging (Item 5) over the top rails of the unit.
- Position the short packaging columns (Item 3) upright within the base packing, resting them on the base of the OmniStand™ (Item 1).
- Position the long packaging columns (Item 4) upright on the base cardboard packaging (Item 2).
- Include the User Manual (PN 51510) with the package. Secure it to the top bar of the balance trainer using a tie wrap.
- Carefully lift the top packaging dust cover (Item 6) onto the unit, ensuring its walls fit snugly inside the base cardboard (Item 2). This may require a two-person lift.
- Affix the asset tag label (Item 7) to the exterior of the fully packaged device.
- Apply one label LBL 0256 (Item 9) to each side of the dust cover and two labels to the top of the package.
- Scan the asset tag barcode into the FGI system.
Visual aids in the original document show the placement of these components and the final packaged state. A "Fragile Medical Equipment" label is also applied.
5. Where Posted
5.1 This document is posted on Master Control.
6. Revision History
6.1 For the complete record of change see Master Control.