Instructions for MotoMotion models including: WRC18TM, 2BA76WRC18MNT016, WRC18TM Remote Control, WRC18TM Remote Control, Remote Control, Control
MotoMotion China Corporation WRC18MNT016 Remote Control 2BA76WRC18MNT016 2BA76WRC18MNT016 wrc18mnt016
WRC18TM Remote Control Instructions 1. Product Overview Product Name Remote Control Product Model No. WRC18TM FCC ID: 2BA76WRC18MNT016 2. Environment requirement Operation temperature: +10~ +40. Storage temperature: 10~65. Operating Humidity10%~80%RHnon-condensing. Storage Humidity10%~ 85%RHnon-condensing. 3. Directions for Operation How to pair the bed with the remote control STEP 1Ensure that the remote control is functioning properly. STEP 2Unplug the AC power cord from the power source. If 9V backup batteries (6LR61 alkaline batteries) were installed in the power supply, remove them. STEP 3Simultaneously press the head up and down buttons for a period of time until the remote control indicator light flashes. How to Setting Programmable Position STEP 1Adjust the bed to the desired memory location. STEP 2Press and hold the button in the upper left corner for about 3 seconds, and the indicator light will change from constantly on to flashing. During the flashing process, press M1 or M2 button to complete the position memory, and the indicator light will turn off. How to charge the remote control There is a USB port on the lower end of the remote control, which can be plugged in to charge the remote control. How to use massage Press the massage button on the handle (head massage or leg massage), press it again to adjust to the second mode, and press it again to adjust to the third mode (a total of three gears can be adjusted). The current specific gear can be seen from the light bar indicator. 4. Matters needing attention 4.1 The function will only work normally in proper working power conditions. 4.2 Remote Control needs DC 3.7-3.85V powered by li-ion batteries. 4.3 The control box is needed for proper control. 4.4 If problems are identified, they must be treated by professional personnel. 5. Additional attention for user 5.1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/ TV technician for help. 5.2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 5.3 For Intentional and unintentional radiators the manual shall caution the user and manufacturer that changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.Microsoft: Print To PDF