Xiaomi Smart Pen
Quick Start Guide
Product Overview
Thank you for choosing the Xiaomi Smart Pen. This product is only compatible with Xiaomi Pad 5.
Pairing and Charging
Please attach the pen horizontally to the middle of the tablet's long side (as shown in the diagram), perform Bluetooth pairing, and start charging.
Note: Please enable the Bluetooth function on your tablet beforehand.
For more information, please visit our official website: www.mi.com/global/service/userguide
Diagram Description
The Xiaomi Smart Pen features the following parts:
- Tip: The writing and drawing end of the pen.
- Secondary Button: A button located on the side of the pen.
- Main Button: Another button, likely the primary control, also located on the side.
WEEE (Waste Electrical and Electronic Equipment)
Special precautions must be taken to dispose of this product safely. This marking indicates that this product should not be disposed of with other household waste in the EU.
To prevent environmental or human health damage due to improper waste disposal and to promote the sustainable reuse of material resources, please reuse responsibly. To recycle your device safely, use the return and collection systems or contact the retailer where the device was originally purchased.
Environmental Statement
To view our environmental statement, please visit the following link: www.mi.com/en/about/environment
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Additional safety information and precautions can be found at the following link: www.mi.com/en/certification
Important Safety Information
Read all safety information below before using the device:
- Using unauthorized cables, power adapters, or batteries may cause fire, explosion, or other hazards.
- Only use accessories that are compatible with your device.
- The operating temperature of the device is 5°C to 40°C. Using this device in an environment outside this temperature range may damage the device.
- If your device has a built-in battery, do not attempt to replace the battery yourself to avoid damaging the battery or the device.
- Misuse of the battery may cause fire or explosion. Dispose of the device, its battery, and accessories, or recycle them in accordance with your local regulations.
- Do not disassemble, strike, crush, or burn the battery. If the battery appears deformed or damaged, stop using it immediately.
- Do not short-circuit the battery, as this may cause overheating, burns, or other injuries.
- Do not place the battery in a high-temperature environment. Overheating may cause an explosion.
- Do not disassemble, strike, or crush the battery, as this may cause the battery to leak, overheat, or explode.
- Do not burn the battery, as this may cause fire or explosion.
- If the battery appears deformed or damaged, stop using it immediately.
- The user must not remove or replace the battery. Battery replacement or repair should only be performed by an authorized service center of the manufacturer.
- Keep your device dry.
- Do not attempt to repair the device yourself. If any part of the device is not working properly, contact Mi customer service or take your device to an authorized repair center.
- Connect other devices in accordance with their instructions. Do not connect incompatible devices to this device.
- Your device is not a toy. As with all electrical products, precautions should be taken during handling and use of electrical products to reduce the risk of electric shock. If parents choose to allow children to use the device, they should warn the child of potential hazards during use and handling of the device.
Precautions
- Follow all applicable laws and regulations that restrict the use of the device in specific situations and environments.
- Do not use the device in operating rooms, emergency rooms, or intensive care units of hospitals. Always follow all hospital and healthcare facility rules and regulations.
- If you have a medical device, please consult your doctor and the device manufacturer to determine if the device could interfere with the operation of the device. To prevent potential interference with a pacemaker, always maintain a minimum distance of 15 cm between the device and the pacemaker.
- To avoid interference with medical devices, do not use the device near hearing aids, cochlear implants, or other similar devices.
- Do not use the device in places with high humidity, such as bathrooms. This may cause electric shock, injury, fire, and damage to the charger.
EU Regulations
RED Conformity Statement
Xiaomi Communications Co., Ltd. hereby declares that this product M2107K81PC is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and RoHS Directive 2011/65/EU.
The full text of the EU Declaration of Conformity is available at the following internet address: www.mi.com/en/certification
Legal Information
This device can be used in all EU member states. Please observe domestic and local regulations where the device is used.
Restrictions in the 2.4 GHz band:
Norway: This subsection does not apply to the Svalbard archipelago within 20 km of the center of Longyearbyen.
Frequency Bands and Power
This device only offers the following frequency bands in EU regions and maximum radio-frequency power:
- 2.4GHz Bluetooth: 20 dBm
- Wireless Charging: 145 KHz < 42 dBuA/m at 10m distance
REGULATORY STATEMENT
Notice
Federal Communications Commission (FCC): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Statement on Radiation Exposure:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) exposure guidelines. This equipment has very low levels of RF energy that are considered to meet the requirements without testing specific absorption ratio (SAR).
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Disclaimer
This quick start guide is published by Xiaomi or its affiliated companies. Improvements and changes to this guide necessitated by typographical errors, inaccuracies in current information, or improvements to programs and/or equipment may be made by Xiaomi at any time and without notice. However, such changes will be incorporated into new online versions of the quick start guide (please see information at www.mi.com/global/service/userguide). All illustrations are for illustration purposes only and may not accurately represent the actual device.
Manufacturer Information
Manufacturer: Xiaomi Communications Co., Ltd.
Manufacturer's Postal Address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China, 100085
Brand: Xiaomi
Model: M2107K81PC
© Xiaomi Inc. All rights reserved.