Smart Z-Finder
Please follow these installation instructions or watch the video found with the QR code here (QR code also on Bridge).
Step 1
Scan QR code in middle of Bridge to bring up witness mark. Move phone left or right to align with jaw's witness mark.
Diagram: Shows the Z-Finder attached to a phone, with arrows indicating movement for alignment. A QR code is visible on the bridge component.
Step 2
Install correct Masks by snapping their pegs into the Z-Finder. Then orient the internal Light Baffle to match your screen size.
Diagram: Illustrates the masks being inserted into the Z-Finder and the light baffle being adjusted for screen size. Two sizes are indicated: Smaller screens (~6.1") and Larger screens.
Step 3
Attach the Z-Finder's magnetic lock to the Bridge. Using supplied hex key, loosen 4 screws. Move Z-Finder up or down to align with phone screen, then press Z-Finder flush to phone screen and tighten 4 screws.
Diagram: Depicts the Z-Finder being magnetically attached to the bridge, with a hex key shown loosening screws. An inset shows the Z-Finder being pressed flush against the phone screen.
Included Components:
- Z-Finder
- Bridge
- 5/64" Hex Key
- Masks
- Light Baffle
- Handstrap
- Diopters (+.5, +1, +1.5, +2)
- Anti-fog Discs
Optional Accessories
- Shoulder Stock
- Director's Grip
- Accessory Rail
- Brow
Separation
Place 2 fingers around knob and thumb in recessed area. Angle Z-Finder down and pull to break magnetic lock.
Diagram: Shows hands separating the Z-Finder from the bridge by pulling downwards on the Z-Finder while holding the knob.
Step 4
Push down on top jaw and twist red knob clockwise to lock.
Diopter/Anti-Fog
To replace the Anti-fog disc, or if necessary, to change the diopter to achieve focus, unscrew lens ring with fingers.
Anti-Fog: To replace Anti-Fog, rotate to drop out disk. On new disk, remove protective film from each side and insert into eyecup.
Diopter: To add or change diopter, remove Anti-Fog disc if installed. Insert new diopter in orientation shown. Replace Anti-Fog disc.
Secure lens ring with fingers.
Diagram: Illustrates the lens ring, diopter, and anti-fog disc components, showing how to unscrew the ring and replace the discs.
