Quam Speakers
Installation Guide for TEKVOX models including: Quam System 15-8 2 Feet Tile Replacement Loudspeaker, 2 Feet Tile Replacement Loudspeaker, Tile Replacement Loudspeaker, Replacement Loudspeaker, Loudspeaker
31 mag 2024 — INSTALLATION INSTRUCTIONS. 1. Cut ceiling tile as required: 2' x 2' tile – No cutting required. 2' x 4' tile – Cut tile in half on 4' side.1 pagina
| TEKVOX
File Info : application/pdf, 1 Pages, 296.63KB
DocumentDocument2 'X 2' TI L E RE P LACE ME NT LOUDSP EA KE R SYSTEM 15/8 Installation Instructions APPLICATION Intended Use: Program Material: Installation: Mass notification and emergency communications Signal tones and voice Fits into a 2' x 2' or 2' x 4' ceiling tile grid INSTALLATION INSTRUCTIONS 1. Cut ceiling tile as required: 2' x 2' tile No cutting required. 2' x 4' tile Cut tile in half on 4' side. 2. Required only if using conduit clamp fitting other than what is provided with product. a. Loosen, but do not remove screws on cover plate; slide plate to large keyhole position and lift plate from assembly. b. Remove cable/conduit clamp fitting from cover plate; Install UL Listed metallic enclosure entry fitting for plenum cable or flex whip. c. Feed supply cable through whip to speaker wires. Make connections per wiring diagram; Use appropriate connectors to meet any required codes. d. Replace cover plate and tighten cover plate screws. When cover plate is secured, all connections/splices must be inside of the enclosure. 3. Make the necessary field wiring connections. 4. Place assembly onto ceiling grid, install 24" T-bar trim piece where required (not supplied). TIE-OFF TAB 4X IMPORTANT: · AHJ/ local codes may require tie-off to structure. Bend up tie-off tabs as shown above and install as directed. · AHJ/ local codes may require tie-down to grid. Recommended fasteners (not supplied): Erico/Caddy part ATA4i and 14"- 20 x 2" bolt, or equivalent. Attach to T-bar as directed with threaded hole over the edge of speaker assembly. Thread bolt through hole until snug against back of speaker assembly. 5. Place remaining ceiling tile into grid opening as required. a. Connect the positive (red) wire from the SYSTEM 15/8 to the positive lead from the field wiring. b. Connect the negative (black) wire from the SYSTEM 15/8 to the negative lead from the field wiring. All connections/splices must be inside of the enclosure. c. Tighten screws on cable clamp. IMPORTANT: · Verify all code requirements with local AHJ before selecting connection method. · Using code compliant connectors for all field wiring. Quam Nichols Company | 234 East Marquette Road | Chicago, IL. 60637 | t: 800-633-3669 | f: 888-633-3669 | e: NeedNow@QNC.com | QuamSpeakers.com ©2020 Quam Nichols Company reserves the right to make changes and/or improvements to its products at any time and without notice. | v.2030