Rugged Radios • UTV & Off Road Communication Equipment and Accessories
Installation Guide for RUGGED models including: MT-DMU-RUGGED, MT-DMU-RDM, MT-DMU-25WP, MT-DMU-ICOM, MT-DMU-KEN, MT-DMU-MOTO, MT-DMU Series Multi Mount Insert Intercom Radio, MT-DMU Series, Multi Mount Insert Intercom Radio, Mount Insert Intercom Radio, Insert Intercom Radio, Intercom Radio, Radio
Multi Mount Insert or Standalone Mount for Intercom and Radio – Rugged Radios
Inserto de montaje múltiple o soporte independiente para intercomunica – Rugged Radios
File Info : application/pdf, 5 Pages, 1.76MB
DocumentDocumentMULTI MOUNT INSERT Multi Mount Insert or Standalone Mount for Intercom & Radio Setup INSTALLATION INSTRUCTIONS MT-DMU-RUGGED MT-DMU-RDM MT-DMU-25WP MT-DMU-ICOM MT-DMU-KEN MT-DMU-MOTO v1.0 - 07/2024 Radios and Mounts List of Mounts and Compatible Radios Mobile Radio Rugged M1/G1/G4/RM45/RM60/GMR45 Rugged RDM Rugged GMR25 Icom F5021 Kenwood TK7360 Motorola CM300D & Motorola Vertex VX2200 SKU MT-DMU-RUGGED MT-DMU-RDM MT-DMU-25WP MT-DMU-ICOM MT-DMU-KEN MT-DMU-MOTO NOTE: Instructions may vary slightly between mount part numbers. The mount shown in the instructions is the MT-DMU-RUGGED. NOTE: The only Intercoms that are compatible with these part numbers are the Rugged 696 & 696+ Intercoms. Equipment Used Parts List · QTY: (1) INTERCOM · QTY: (1) MOBILE RADIO · QTY: (1) 10 mm Socket or Open-End Wrench · QTY: (1) 7 mm Open-End Wrench or Power Phillips Screwdriver 1. Installing the Intercom Step 1 First, insert the supplied hex bolt facing inward into the holes of the mount then insert the supplied lock washer and nut on either side. Step 2 Feed the intercom through the face of the mount, aligning the hex bolt heads with the channel on either side of the intercom. Note how the bolts line up and position themselves in the slot. Step 3 Continue sliding the intercom flush to the face of the mount. Once in place, tighten the nuts with the use of 10mm Socket or Open-End Wrench to secure it in place. 2. Installing the Radio Step 4 On your radio, remove the Phillips Hex screws from either side using the 7mm Socket or Open-End Wrench. Step 5 Position and Insert the radio face thru the back toward the front of the mount. Step 6 Align the holes on the mount with the holes on the radio then reinstall the Phillips Hex screws into either side. 3. Step 7 Tighten the Phillips Hex Screws with the use of 7mm Open-End Wrench or Power Phillips Screwdriver to secure it in place. Radio & Intercom Mounting Complete Now that the Radio and Intercom are mounted, the unit can now be installed to your vehicle. Once Installed in the vehicle, Make sure to wire your Radio and Intercom. Clean up any wiring and proceed to test the components in your vehicle. Check operation separately to assure each device is functioning properly. Once all devices are on and functioning properly, re-check with the engine running. If any electronic noise is introduced in the system while the engine is running make sure all devices are not connected to 12V power. See the device manufacturer for available accessories. For further information, questions, and set ups, you can visit the website or call our team who is already ready to help you out. RUGGEDRADIOS.COM · 1 (888) 541-7223 · Ask For Tech Support 4.