Lorelli Navigator Car Seat Manual

Important Information

Please keep this manual for future reference and read it carefully.

Notice

1. This is a "universal" child securing device, approved according to Rule No. 44, for general use in vehicles. It is suitable for most, but not all, car seats.
2. Correct placement is confirmed if the vehicle manufacturer has declared in the vehicle's manual that "Universal" Safety devices for children of this age group can be used in the vehicle.
3. This child securing device is classified as "universal" under more stringent conditions than previous models without this remark.
4. If in doubt, consult the manufacturer of child safety equipment or the seller.

This device is only suitable for vehicles equipped with 3-point static or 3-point retractor safety-belts, approved to UN/ECER Regulation No. 16 or other equivalent standards.

Important Safety Instructions

• Ensure the vehicle is equipped with a 3-point safety belt approved according to Rule No. 16 of the ECE at the UN or other equivalent standards.
• Hard components or plastic parts of the safety device should not be jammed by movable seats or doors during everyday use.
• All belts fastening the car seat must be tight, restrain the child, be adjusted to their body, and not twisted.
• The device must be replaced if it has undergone significant load from an accident.
• The waist belt must be adjusted low so that the child's pelvis is securely restrained.
• Do not make changes or additions to the safety device without approval from the competent authority.
• Follow installation instructions closely to avoid injury to the child.
• Never leave the child unattended in the safety device.
• Secure any luggage or other items that could cause injury in a collision.
• The safety device for children should not be used without its cover.
• Do not replace the seat cover with another unless recommended by the manufacturer, as it is an integral part of the child securing system.
• Your child seat can only be fitted into a passenger seat with a lap and diagonal seat belt. Do not use any load-bearing contact points other than those described and marked on the child restraint. Ensure the vehicle seat buckle is not positioned in or in front of the specified belt guide of the child restraint system.

Washing Instructions

1. The car seat can be cleaned with lukewarm water and soap. Do not use abrasive cleaners like abrasives or thinner.
2. The cover should be washed by hand at a maximum temperature of 30°C. Do not put it in the dryer; allow it to air dry.
3. Plastic parts can be cleaned with a damp cloth. Do not use any solvents.

Installation of the Car Seat

Group I (9-18 kg)

The car seat should be used with the backrest and headrest. Secure the child using the safety belts and fit the car seat to the vehicle's seat using the car's 3-point belt system. The shoulder belt should not pass through the headrest hook.

On the back of the car seat, there are 3 pairs of openings for adjusting the height of the shoulder belts according to the child's weight. The level of the openings should not be lower than the child's shoulders when seated.

1. After threading the shoulder belt through the corresponding openings on the back of the seat, check that the shoulder belt height matches the child's shoulder height.
2. Fit the car seat in a forward-facing position using the car's 3-point belt system, keeping the seat upright. Position the car seat close to the vehicle seat and fasten the safety belts.
3. Place the headrest.
4. Press the adjusting button on the front of the seat and pull the strap to unfasten the child's belt.
5. Press the red button on the buckle and remove the shoulder belts. Place your child in the car seat, ensuring the belt is not twisted or knotted. Insert both ends of the belt into the buckle until a "click" is heard, ensuring the belt is secure.
6. Tighten the shoulder belts by pulling the adjustable strap on the front of the car seat.
7. To release your child, press the adjusting button on the front of the car seat and simultaneously pull the shoulder belts. Then press the red button on the buckle, remove the shoulder belt, and allow the child to exit.

Group II (15-25 kg) with backrest and headrest

The car seat should be used with the backrest and headrest. Use the car's 3-point belt system to secure your child and fit the car seat in the vehicle. The shoulder belt must pass through the headrest's hook.

1. Unfasten the shoulder belt from the yoke on the back of the backrest, draw the belts out from the openings on the back of the backrest and seat.
2. Adjust the headrest height according to your child's height. The upper shoulder guide hook on the headrest should be slightly higher than the child's shoulders. Adjust by pulling up or down.
3. Place the car seat onto the vehicle seat in a forward-facing position. Ensure the car seat is well adjusted to the vehicle seat.
4. Place your child in the car seat and ensure the belt is not twisted or knotted. Position the car's lap belt under both armrests and over the child's lap. Thread the shoulder belt through the armrests and the upper shoulder guide on the headrest. Secure the metal inserts of the belt into the buckle.

Group II (15-25 kg) without backrest and headrest

Remove the backrest and headrest. The car seat should be used only as a seat. Use the car's 3-point belt system to secure your child and fit the car seat in the vehicle.

When the angle between the base and backrest is more than 90 degrees, remove the backrest and headrest. Place the seat in a forward-facing position in the vehicle. Place the child in the seat and ensure the belt is not twisted or knotted. Position the car's lap belt under both armrests and over the child's lap. Secure the metal inserts of the belt into the buckle.

Group III (22-36 kg)

Remove the backrest and headrest. The car seat should be used only as a seat. Use the car's 3-point belt system to secure your child and fit the car seat in the vehicle.

Place the seat in a forward-facing position in the vehicle. Place the child in the seat and ensure the belt is not twisted or knotted. Position the car's lap belt under both armrests and over the child's lap. Secure the metal inserts of the belt into the buckle.

Contact Information

Didis OOD, Bulgaria
Shumen 9700, ul. "Trakiya-iztok" № 6
Tel.: 054/850 830
e-mail: home.market@didis-ltd.com
e-mail: export@didis-ltd.com

Didis LTD, Bulgaria
Shumen 9700, № 6 Trakia-iztok street
Tel.: +359 54 850 830
e-mail: home.market@didis-ltd.com
e-mail: export@didis-ltd.com

Website: www.lorelli.eu