Assembly and Installation Guide
Important Safety Information
Please read and save these instructions for future reference. When using electrical equipment, always follow basic safety precautions:
- The lamps should be installed by authorized and qualified technicians, adhering to current electrical installation regulations.
- The manufacturer is not liable for injuries or damage caused by improper use of the light.
- Before installation, ensure the mains power is off. Turn off the circuit breaker or remove the fuse. The light switch must be in the "OFF" position.
- Warning: Before drilling mounting holes, check your chosen location for any gas, water, or electrical utility lines to avoid damage.
- This unit contains no user-serviceable parts.
- Keep the device out of reach of children under 3 years old.
- Risk of electric shock: Do not use in wet locations or where directly exposed to water.
- Supply terminals: L = Phase, N = Neutral conductor, [earthed conductor] = Earthed conductor.
Last updated: 16/12/2024
Installation Instruction
| Component | Quantity | Included | Not Included |
|---|---|---|---|
| Lighting Source | LED 5W | ✔️ | ❌ |
| Mounting plate | x1 | ✔️ | ❌ |
| Expanded plastic anchors | x2 | ✔️ | ❌ |
| Mounting screws | x2 | ✔️ | ❌ |
Step 1: Prepare Mounting Location
Mark and drill holes on the wall according to the mounting plate template. Insert expanded plastic anchors if required. (Diagram shows screws and anchors being prepared for wall mounting).
Step 2: Attach Mounting Plate
Secure the mounting plate to the wall using the provided screws. (Diagram shows the mounting plate being screwed into the wall).
Step 3: Mount Fixture and Connect
Align the fixture with the mounting plate and secure it. Connect the wiring according to local electrical codes. (Diagram shows the fixture being attached to the plate, with wiring connections indicated).
Remote Control Functions:
The fixture is controlled by an RF Wireless remote. Functions include:
- ON/OFF: Powers the light on or off.
- Stepless Dimming: Adjust brightness using the '+' and '-' buttons.
- Timer Function: Set automatic shut-off for 15, 30, or 60 minutes.
