XYZ OMEGA Instructions Manual
Package Contents
- Motherboard screws (x18)
- Power screws (x6)
- HDD screws (x9)
- Copper pillars (x3)
Motherboard Wire Interface Schematic
Connectors include: POWER SW, HDD LED, RESET, POWER LED +, POWER LED -. Please refer to your motherboard's manual for specific connection instructions.
Product Dimensions
Height: 390mm, Width: 230mm, Depth: 375mm.
Front Panel I/O Ports
- USB3.0 x2
- HD AUDIO
- USB2.0
- LED Button
- RESET
- POWER
Case Overview
Views include: Top, Front, Left (open side panel), Right (open side panel), Back, and Bottom.
Chassis Disassembly Diagram
Diagram shows the general layout for chassis disassembly.
Side Panel Installation and Removal
- Glass side panel: Pull the tab and pull it out.
- Metal side plate: Buckle the side plate and fix it with two screws.
Power Supply Installation
The power supply is fixed by aligning screws with the designated holes. Note: Hole locations may vary slightly depending on the power supply model; use the actual object as the standard.
Motherboard Installation
Install the motherboard according to its type (M-ATX/ITX). Copper pillars may need to be manually rearranged to match your motherboard's fixing locations. CPU cooler height limit: 190mm.
Graphics Card Installation
Maximum graphics card length supported: 340mm.
Front Panel Removal
To remove the front panel, pull it by hand, firmly from the bottom of the panel.
Fan Compatibility
- Front: Supports 2 x 120mm or 140mm fans.
- Rear: Supports 1 x 120mm fan.
- Top: Supports 2 x 120mm or 140mm fans.
Radiator Support
- Front: Supports 240mm radiators.
- Rear: Supports 120mm radiators.
- Top: Supports 240mm radiators.
SSD Installation
Align the SSD mounting holes and fix them with screws. Supports up to 3 SSDs.
HDD Installation
- Remove the hard disk rack and secure the hard disk with screws.
- Lock the two slide rail screws on the left side of the HDD, slide them into the hard disk rack, and secure the right side of the hard disk with screws.
Supports up to 2 HDDs.
PWM and ARGB Controller Instructions
Connections:
- Connected with 3 small PWM 4-PIN connectors.
- SATA power connector (from PSU).
- Interface for 5V 3PIN LED wire, supports 6 FANs.
- Can switch to the computer's LED button.
- PWM speed adjusting line.
- Universal link to motherboard 5V 3pin connector.
To use the ARGB feature: Hold down the reset key for 5 seconds.
More Information
Find out more about us at www.xyzpcgear.com.
