AX3000 Wi-Fi 6 Bluetooth 5.0 PCIe Adapter

1. Product Brief Introduction

The AX3000 is a 2.4 GHz and 5 GHz dual-band Wi-Fi 6 PCI Express card designed to meet the high-speed demands of esports. It is compatible with PCIe X1, X4, X8, or X16 slots on desktop computers. The motherboard must support PCIE V2.1Gen2 and USB2.0 interfaces.

Utilizing the Intel AX200 chip, this adapter is compatible with IEEE 802.11.b/g/n/ac/ax standards. It supports high-performance dual-channel networking and full-duplex communication, offering transmission rates up to 2974 Mbps. It also supports Bluetooth 5.0.

Driver support is available for Windows 10, Linux, and Chrome operating systems.

The device is presented as a PCIe card with two external antennas, a Wi-Fi module, and connections for power and the PCIe interface.

2. Product Packaging

• 1 x WiFi 6 Network Card
• 1 x Driver CD
• 1 x USB Cable
• 1 x Warranty Card

3. Driver Installation

1. Plug the wireless network card into the PCI-E port of your computer.
2. Insert the USB cable into the 4-PIN socket on the network card and connect the other end to the USB pin header on the motherboard.
3. Boot up the computer.
4. When the "Find New Hardware Wizard" dialog box appears, it is recommended to choose "Cancel". Alternatively, select "Install from list or specified location" and click "Next" to manually install the driver.
5. Insert the provided CD-ROM into the computer's drive.
6. Locate the driver installation program on the CD and double-click "Setup" to begin the installation.
7. The installation program will automatically install the driver and wireless configuration software. Follow the on-screen prompts by clicking "Next".
8. Click "Finish" to complete the driver installation.
9. Please note that this product's driver only supports 64-bit operating systems.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

To comply with FCC RF exposure compliance requirements, this grant is applicable only to mobile configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.