Weber Genesis NG Assembly Guide
This guide provides step-by-step instructions for assembling your Weber Genesis NG grill. Please read all instructions carefully before beginning assembly.
Before You Begin
- Cut all four corners of the carton and fold sides down.
- Assemble the grill on a flat, level, and soft surface.
- Remove protective film from stainless steel parts before installing.
- Do not use power tools for assembly.
- Two people are required for assembly.
- There may be visual differences between illustrations and the model purchased.
- Always keep the lid closed when assembling or moving your grill.
Tools Included
- Wrench
Tools Required
- Screwdriver
- Wrench
Parts Identification
The following parts are included in your assembly:
- A
- Grill Grates
- B
- Warming Rack
- C
- Wheels and Supports
- D
- Side Tables and Bottom Shelf
- E
- Control Panel and Side Panel Components
- F
- Burner Assembly
- G
- Side Burner Components
- H
- Lid and Hood Components
- I
- Cabinet and Door Components
- J
- Top Shelf and Drip Tray
- K
- Ignition Components and Batteries
Assembly Steps
- Step 1: Prepare the carton by cutting the corners and folding down the sides.
- Step 2: Unpack all components and verify against the parts list. Save all hardware.
- Step 3: Attach the side panels to the base using screws (A). Ensure correct orientation as indicated by checkmarks.
- Step 4: Attach the front panel to the base using screws (A).
- Step 5: Slide the bottom shelf into place and secure with screws (A).
- Step 6: Attach the side tables using screws (A).
- Step 7: Install the main body panels using screws (A).
- Step 8: Attach the lower side panels using screws (A).
- Step 9: Attach the rear panel using screws (A).
- Step 10: Attach the side panels to the main body using screws (A).
- Step 11: Attach the control panel and side panels using screws (C).
- Step 12: Install the wheels. Ensure they are locked in place.
- Step 13: Connect the gas lines.
- Step 14: Attach the side burner components.
- Step 15: Attach the side panels to the main body using screws (C).
- Step 16: Connect the igniter wires and install batteries (K).
- Step 17: Attach the warming rack supports.
- Step 18: Install the burner assembly.
- Step 19: Attach the drip tray and grease management system.
- Step 20: Install the side tables.
- Step 21: Attach the lid and hood components.
- Step 22: Install the side burner components.
- Step 23: Attach the side panels to the main body using screws (D).
- Step 24: Connect the gas manifold.
- Step 25: Attach the side panels using screws (D).
- Step 26: Install the igniter module.
- Step 27: Attach the side panels using screws (D).
- Step 28: For 335 models only: Connect the wiring harness.
- Step 29: For 435 models only: Connect the ring connector to the manifold with a screw.
- Step 30: Attach the side panels using screws (D).
- Step 31: Attach the side panels using screws (D).
- Step 32: Attach the front panel.
- Step 33: Attach the side panels using screws (E).
- Step 34: Connect the igniter wires.
- Step 35: Attach the side panels.
- Step 36: Attach the side panels using screws (E).
- Step 37: Attach the side panels using screws (E).
- Step 38: Attach the lid and extra fasteners.
- Step 39: Attach the handle using screws (K).
- Step 40: Install the grates and warming rack.
- Step 41: Install the side tables.
- Step 42: Install the control knobs.
- Step 43: Attach the side panels.
- Step 44: Refer to the Troubleshooting section of your Owner's Guide for lighting instructions.
- Step 45: Save hardware.
- Step 46: Attach the side panels.
- Step 47: Attach the side panels.
- Step 48: Attach the side panels using screws (E).
- Step 49: Install the side burner components.
- Step 50: Install the grates.
- Step 51: Install batteries (K).
Important Safety Information:
- Make sure all parts are assembled and all hardware is tightened before operating your grill.
- Remove all packing material before operating your grill.
Register Today:
Register your grill to receive exclusive WEBER content that is sure to make you the ultimate backyard hero.
Contact Information:
- U.S./EE. UU./États-Unis: 1-800-446-1071
- Mexico/México/Mexique: 01 800 0093237
- Canada/Canadá/Canada: 1-800-446-1071
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc. Android and Google Play are trademarks of Google Inc.
© 2021 Designed and engineered by Weber-Stephen Products LLC, 1415 S. Roselle Road, Palatine, Illinois 60067 USA. www.weber.com