Haruto Wall light, Metal, Hammered brass, Clear Glass | Lamp GeniusWall Lights | Free UK Delivery Over £99 | Lamp Genius
Instruction Manual for Lamp Genius models including: LI178413 Haruto Wall Light, LI178413, Haruto Wall Light, Wall Light, Light
Haruto Wall light, Metal, Hammered brass, Clear Glass | Lamp Genius
File Info : application/pdf, 2 Pages, 566.49KB
DocumentDocumentInstallation and Safety Instructions LI178413 - Haruto Wall light, Metal, Hammered brass, Clear TSroaubfeletsyhoWotiangrnings Glass Trehfeesreenicnes.trIuf cytoiounasraerien faonr yyoduorusbat faebtyo.uPt lienasstaellirnegadthtihsrporuogdhutcht,ecmonthsourlot uagqhulyalbifeiefdoreeleucstericaiannd.retain them for future This product is only suitable for connection to a 240V~ 50Hz supply in accordance with current IEE wiring regulations, and should be installed in accordance with local building regulations. It is for domestic ceiling use only, and is not suitable for a bathroom location. This fitting is a Class II, Double Insulated product and does not require an Earth. Live or Neutral must not be connected to Earth. IMPORTANT: Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation. he product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for "masonry" only. Other fixings are not supplied and must be purchased. Decide on the position of the light fitting or remove existing light fitting. Note the position of the electrical connections, and ensure there is a solid mounting surface, Preferably a wooden joist or joist bridge, to support the weight of the light fitting. Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation. Never put anything on the product or hang anything on any part of this product. IMPORTANT: Ensure that all electrical connections are tight and that no loose strands are left out of the terminal. Never fit bulbs of a higher wattage than those specified on the label (as these may cause over heating and damage the fitting). Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice. TCroaubrleesahonodtinmg aintenance For Wall Lights For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use). Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product. TTroruobulesbhloeostihngooting When the bulb does not light after installation: > Ensure there is no electricity failure. > Ensure all the connections are secure. If you have any doubt about installation/use of this product, consult a qualified electrician. 90598_90600_90602_106717_106719_106721_06072023 UK Manufacturer: BH17 7BY EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg TArosubsleesmhobotliyngInstructions 3 1 5 2 7 6 4 UK Manufacturer: BH17 7BY EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg