User Manual for Trudian models including: Wiegand Access Control Reader, Access Control Reader, Control Reader
Файлы - Trudian Technology
Ð¤Ð°Ð¹Ð»Ñ - Ð¤Ð°Ð¹Ð»Ñ - Trudian Technology
Before powering up, you must confirm the voltage of the power supply and the positive and negative terminals of the power supply.
Wiegand Access Control Reader User Manual Wiegand Access Control Reader User Manual Contents 1. PRODUCT OVERVIEW .............................................................................. 1 2. WIEGAND READER INSTALLATION DIAGRAM ..........................................2 3. WIRING INSTRUCTION .............................................................................3 Wiegand Access Control Reader User Manual 1. Product Overview Parameter: Working voltage DC12V±10% Swipe distance 0~4CM Working current 60mA±20mA Card reading type IC card Communication mode Wegen 26 / Wegen 34 Issuing mode management platform card issuing Working temperature -20~-70 Card capacity 1000 Relative humidity 10%~93% Open mode swipe card, APP, remote, password (optional) Size 86 * 86 * 8MM Installation method Control box: hanging installation reading head : 86 box embedded installation.86 box requires a depth of 50MM inside 1 Wiegand Access Control Reader User Manual 2. Wiegand Reader Installation diagram Connect the signal line in the back of the read head device as shown in the figure below. Install the reading head device into the 86 box, (note that you need to use the embedded wall inside the depth of 50MM style 86 box), lock the screws to fix, as shown in the figure below. Read the head panel and read the head body snap together, first from the upper snap down and then press the lower and bottom screw hole alignment; finally in the bottom of the anti-theft screw hole screwed on the countersunk head machine wire within the plum security screws fixed,as shown in the figure below. 2 Wiegand Access Control Reader User Manual 3. Wiring instruction Operating mode selection Wire color Red Line Blace Line Green Line White Line Yellow Line Blue Line Function Description DC12V GND D0 D1 WG34 LED/BZ Notes 1.Before powering up, you must confirm the voltage of the power supply and the positive and negative terminals of the power supply. 2.When using external power supply, it is recommended tos hare the power ground with the controller power supply. 3.Read the head to the control box wire, it is recommended to use 8-core shielded multi-strand twisted pair network cable.Three of the cores standby, if you do not need to read the head sound and LED light feedback legal card, may not be connected to LED/BZ line, Wegen data line D0 and D1 is recommended for each other better twisted pair, line cross-sectional area recommended 0.22 square millimeters or more, it is recommended that the wiring length does not exceed 100 meters,shielded wire connected to the control box motherboard GND, thickened or double stranded together a power supply to the reading head, help to enhance the performance of the reading head. .(You can also use other multi-core shielded Category 5 wire) 3 Wiegand Access Control Reader User Manual 4WPS 文字