E-LD500 2 ELOPS Electric Bicycle Assembly Instructions

Package Contents

The assembly kit includes the main bicycle frame, wheels, pedals, handlebars, seat post, battery, charger, and necessary tools and hardware (e.g., M6x20mm screws).

Step 1: Attach Pedals

Identify the left (L) and right (R) pedals. Screw the right pedal clockwise into the right crank arm and the left pedal counter-clockwise into the left crank arm. Ensure they are tightened securely.

Step 2: Mount Handlebars

Insert the handlebar stem into the head tube. Align the handlebars with the front wheel and tighten the stem bolts to 6 Nm. Ensure the handlebars are straight before fully tightening.

Step 3: Install Seat Post

Insert the seat post into the seat tube. Adjust to the desired height and tighten the seat clamp bolt to 6 Nm.

Step 4: Attach Front Wheel

Align the front wheel with the fork dropouts. Secure the wheel using the provided axle nuts or quick-release lever. Ensure the wheel spins freely and is centered.

Step 5: Attach Rear Wheel

Align the rear wheel with the rear dropouts. Secure the wheel using the provided axle nuts or quick-release lever. Ensure the wheel spins freely and is centered.

Step 6: Inflate Tires

Check the tire sidewall for recommended pressure (e.g., 3.0 - 7.0 BAR / 43-79 PSI). Use a pump to inflate the tires to the correct pressure. A 'CLIC' sound may indicate the valve is properly seated.

Step 7: Final Checks

Ensure all bolts and nuts are tightened securely. Check brake function and gear shifting. Verify that the battery is properly connected and charged.