User Guide for WyreStorm models including: EXP-EX-80-KVM, 80m KVM UTP HDMI Extender Over Ethernet, HDMI Extender Over Ethernet, 80m KVM UTP Over Ethernet, Over Ethernet, Ethernet
2022-11-13 — IMPORTANT! Installation Requirements. • Visit the product page to download the latest firmware, document version, additional documentation ...
File Info : application/pdf, 4 Pages, 1.56MB
DocumentDocumentHDMI KVM Extender Set with USB 2.0 Extension EXP-EX-80-KVM Quickstart Guide WyreStorm recommends reading through this document in its entirety to become familiar with the product's features prior to starting the installation process. IMPORTANT! Installation Requirements · Visit the product page to download the latest firmware, document version, additional documentation, and configuration tools. · Read through the Wiring and Connections section for important wiring guidelines before creating or choosing premade cables. In the Box 1x EXP-EX-80-KVM Transmitter 1x EXP-EX-80-KVM Receiver 1x 12V DC 2A Power Supply (US/UK/EU/AU) 1x USB Type B to Type A Cable 4x Mounting Brackets Basic Wiring Diagram Personal Computer HDMI Monitor/Display 12V DC Power Supply HDMI USB KEY HDMI Cat5e/6/6a/7 USB Power EXP-EX-80-KVM Transmitter (TX) Cat5e/6/6a/7 HDMI Keyboard and Mouse USB EXP-EX-80-KVM Receiver (RX) Copyright © 2020 WyreStorm Technologies | wyrestorm.com EXP-EX-80-KVM Quickstart Guide | 200330 1 of 4 UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) support@wyrestorm.com Transmitter (Front/Rear) ABC D E FG Receiver (Front/Rear) ABC D E FG HDMI In Power LED Power In Status LED E UTP Out F USB LED G USB (PC) Host 19-pin type A HDMI female Supports HDMI and DVI/D with adapter Solid: The unit is powered On Off: The unit is powered Off 5.5mm Screw Down Barrel Jack Connect to the included 12V DC 2A power supply to the transmitter. A power supply is not required on the other end as it will be powered using PoC. Flashing: The receiver is operating normally. Off: The receiver is Not operating normally. 8-pin RJ-45 female Connect the transmitters UTP OUT to receivers UTP IN. Solid: USB linked Flashing: USB data transmitting Off: No USB device connected USB Type B female Connection of USB Host device HDMI Out Power LED Power In Status LED E UTP In F USB LED G USB Device 19-pin type A HDMI female Supports HDMI and DVI/D with adapter Solid: The unit is powered On Off: The unit is powered Off 5.5mm Screw Down Barrel Jack Connect to the included 12V DC 2A power supply to the transmitter. A power supply is not required on the other end as it will be powered using PoC. Flashing: The receiver is operating normally. Off: The receiver is Not operating normally. 8-pin RJ-45 female Connect the transmitters UTP OUT to receivers UTP IN. Solid: USB linked Flashing: USB data transmitting Off: No USB device connected 2x USB Type A female Connection of USB devices such as keyboards and mice. Copyright © 2020 WyreStorm Technologies | wyrestorm.com EXP-EX-80-KVM Quickstart Guide | 200330 2 of 4 UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) support@wyrestorm.com Wiring and Connections WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in it's entirety before running or terminating the wires to ensure proper operation and to avoid damaging equipment. . IMPORTANT! Wiring Guidelines · The use of patch panels, wall plates, cable extenders, kinks in cables, and electrical or environmental interference will have an adverse effect on signal transmission which may limit performance. Steps should be taken to minimize or remove these factors completely during installation for best results. · WyreStorm recommends the use of shielded category cable to minimize signal noise and interference. · WyreStorm recommends using pre-terminated HDMI cables due to the complexity of these connector types. Using pre-terminated cables will ensure that these connections are accurate and will not interfere with the performance of the product. Troubleshooting No or Poor Quality Picture (snow or noisy image) · Verify that power is being supplied to the transmitter and receiving device · Verify that all HDMI and UTP connections are not loose and are functioning properly · Verify that the UTP cable is properly terminated following EIA568B standard · Verify that the output resolution of the source and display is supported by this extender Failed USB Connection or Slow Transmission rate · Ensure the category cable length is within the range of requirement, USB HID device is within 80m/260ft, USB storage device is within 60m/200ft. Troubleshooting Tips: · WyreStorm recommends using a cable tester or connecting the cable to other devices to verify functionality. Copyright © 2020 WyreStorm Technologies | wyrestorm.com EXP-EX-80-KVM Quickstart Guide | 200330 3 of 4 UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) support@wyrestorm.com Specifications Audio and Video Inputs Outputs Output Video Encoding Encoding Data Rate End to End Latency (Max) Audio Formats Video Resolutions (Max) Supported Standards Maximum Pixel Clock Communication and Control HDMI UTP USB Power Power Supply PoC Max Power Consumption Environmental Operating Temperature Storage Temperature Maximum BTU Dimensions and Weight Rack Units/Wall Box Height Width Depth Weight Regulatory Safety and Emission Transmitter Receiver 1x HDMI In: 19-pin type A 1x USB Type B 1x UTP In: 8-pin RJ-45 Female 2x USB Type A 1x UTP Out: 8-pin RJ-45 Female 1x HDMI Out: 19-pin type A UTP 6.75Gbps 10s (micro seconds) 2ch PCM | Multichannel up to DTS-X and Dolby Atmos Video Resolution HDMI Cat6 Cat6a/7 1920x1080p @60Hz 12bit 15m/49ft 80m/262ft 80m/262ft Note: WyreStorm recommends the use of shielded category cable to minimize signal noise and interference DCI | RGB 225MHz HDMI 1.3b | HDCP 1.4 | EDID | DVI/D supported with adapter (not included) HDMI 1.3b | HDCP 1.4 | EDID | 2-way PoC IEEE 802.3af 48V 15.4W Max | 2-way 3.6W (per unit) 0 to + 45°C (32 to + 113 °F), 10% to 90%, non-condensing -20 to +70°C (-4 to + 158 °F), 10% to 90%, non-condensing 12.28 BTU/hr <1U 23mm/0.9in 75mm/2.95276in 98.2mm/3.87in 0.22kg/0.48lb (each) CE | FCC | RoHS | RCM | EAC Note: WyreStorm reserves the right to change product specification, appearance or dimensions of this product at any time without prior notice. Warranty Information WyreStorm Technologies LLC warrants that its products to be free from defects in material and workmanship under normal use for a period of two (2) years from the date of purchase. Refer to the Product Warranty page on wyrestorm.com for more details on our limited product warranty. Copyright © 2020 WyreStorm Technologies | wyrestorm.com EXP-EX-80-KVM Quickstart Guide | 200330 4 of 4 UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973) support@wyrestorm.com