User Manual for AMHVMU models including: G19 Heads Up Display Car, G19, Heads Up Display Car, Up Display Car, Display Car, Car
AMHVMU gps speedometer car G19 Heads up display car, GPS speedometer display of travel speed, distance traveled, time, HUD digital speedometer car mph, suitable for all cars : Automotive
GPS speedometer: G19 Tips The operating voltage of this product is 5V, and the voltage higher than 5V is prohibited After the HUD is powered on, the satellite icon flashes, which means that after searching for satellite signals, the icon stops flashing and the number of satellites is displayed, it can be used normally. Display function introduction: 1. Atmosphere decorative light 2. Compass: N (North); S(South); W(West); E(East). The product can only be used normally after the satellite is found 3. Fatigue driving icon , overspeed alarm icon 4. Atmosphere decorative light 5. Multi-function display area: acceleration time driving Angle , driving distance 6. Multi-function display area: Date Altitude , Driving time , Time 7. Atmosphere decorative light 8. Speed display area/unit: MPH (miles), Km/H (kilometers) 9.Atmosphere decorative light Button function: `OK' Short press A. Switch display function B. Switch option in the Settings menu `OK' Long press A. Enter the Settings menu B. After adjusting the parameter value, press for 2 seconds to save and exit Short press: Switch number of satellites, acceleration time, driving angle, driving time Long press: turn off the buzzer alarm sound, and long press again for 2 seconds to turn on the buzzer sound Short press: switch the date, altitude, driving time , clock Long press: The display interface is all bright Setting mode: Long press the "OK" button to enter the setting menu, short press the "OK" button to switch the setting items; after entering the setting items, short press the and to adjust the parameter value, long press the "OK" button to save and exit. Set the function adjustable direction for use Windows item range default Vehicle 50-150 Adjust the parameter value 107 speed when there is an error adjustment between HUD and dashboard. Ex:dashboard displays 100 KM,HUD displays 105 KM. Please adjust the parameter value to 102.(107-5) Section 1 0-300 Alarm after vehicle speed 150 over speed exceeds set point (default alarm parameter value is 150 Km/ H) Set the parameter value screen Section 2 0-300 Alarm after vehicle speed 180 over speed exceeds set point (default alarm parameter value is 180 Km/ H) Section 3 0-300 Alarm after vehicle speed 200 over speed exceeds set point (default alarm parameter value is 200 Km/ H) Fatigue 1.0-8.0 Fatigue driving reminder is 8 8.0 driving hours reminder Brightness 0-11 "0" is automatic light 0 Adjustment sensitivity "1-11" is the manual adjustment range Speed unit 0-1 0--Km/H 0 1--MPH Clock and 0:00-12:00 Calibrate the local time date 0:00-24:00 (default China time) calibration date calibration (After the satellite is found, it will be updated.) Clock 12H/24H The default is 12 hours system 800 12H Factory reset 0-1 The default value is 0. After 0 adjusting to 1, long press the "OK" button to save and exit FAQ 1. No display on the screen, no power Please check whether the USB cable is damaged, or replace the USB line test (please note: do not use the voltage higher than 5V). 2. No speed GPS blinks for searching numbers ongoing.Please move the car to wide road. It will work after GPS light steady. 3. The speed is still displayed after the car stops Unstable signal drift will happen in underground parking lots,tunnels and overpasses.Please drive your car to wide road 4. Speed display is inaccurate a. Check whether the unit is correct, Km/H or MPH (Please refer to setting item 7 for speed unit switching.) b. Please refer to setting item 1 for vehicle speed adjustment. 5. Clock calibration a. HUD defaults to China time +8:00 b. To adjust the time in other countries, please enter Settings Item 8 and adjust by pressing the left and right buttons, 30 minutes/time (for example: South Korea is 1 hour ahead of Beijing time, press right twice) Note: The satellite icon flashing means that no satellite is found, and the time is displayed as the time zone 6. Driving direction is wrong When there is no speed, the satellite cannot identify the driving direction of the vehicle, and can be displayed normally after the driving speed exceeds 5 Km / H. 7. Turn off the alarm sound Long press 2 seconds to turn off the buzzer sound, long press again 2 seconds to turn on the buzzer soundWPS 文字