STARLINK | ADAPTA YA BOMBA YA PERFORMANCE

What's in the Box

The package includes:

• Pipe Adapter Mount
• M6 Button Head Screws (4)
• Hex Wrench (2)

Dimensions:

• Mount Width: 218 mm (8.6 inches)
• Adapter Width: 252 mm (9.9 inches)
• Adapter Height: 233 mm (9.2 inches)
• Pipe Diameter Range: 38-60 mm (1.5 - 2.4 inches)

Installation Steps

1. Download the Starlink App

   Scan the QR code to download the Starlink App. The app will guide you through the setup process.

   [QR Code: setup.starlink.com]

2. Connect the Starlink Cable

   Connect the red-marked connector of the Starlink Performance cable to your Starlink dish by holding the connector and inserting it fully into the dish.

   To remove the cable, twist the collar counter-clockwise and pull to disconnect from the Starlink dish.

   [Image: Diagram showing how to connect the Starlink cable to the dish, with a close-up of the connector and a lock symbol.]

3. Attach the Pipe Adapter to Starlink

   Secure the machine screws provided through the pipe adapter into the back of the Starlink dish. Tighten the four screws using the hex wrench.

   Tighten all 4 corner screws until the bolts reach 7 Nm (5.2 lb-ft). Ensure the mount is securely attached to the Starlink.

   [Image: Diagram showing the pipe adapter being attached to the Starlink dish with screws and a hex wrench. Torque specification: 7 Nm (5.2 lb-ft).]

4. Loosen Mounting Screws

   Using the hex wrench, loosen the mounting screws on the Pipe Adapter until the slot is large enough to fit your mounting pole.

   [Image: Diagram showing the hex wrench loosening screws on the pipe adapter.]

5. Mount Starlink onto Pipe

   Insert the Pipe Adapter onto your mounting pole. Temporarily tighten the mounting screws to ensure the Starlink is stable on the pole.

   Connect the other end of the Starlink cable to the power supply and plug it into a power outlet.

   [Image: Diagram showing the Starlink dish with the pipe adapter mounted on a pole, and the cable connected to the power supply.]

6. Align Your Starlink

   The App will notify you if you need to rotate the Starlink for optimal alignment. Tap the notification to use the alignment tool.

   [Image: Diagram showing a hand holding a phone with the Starlink app open, indicating alignment.]

7. Secure the Connection

   Using the hex wrench, tighten the mounting screws on the Pipe Adapter to secure your Starlink in place.

   Ensure your Starlink is securely connected.

   [Image: Diagram showing the hex wrench tightening the screws on the pipe adapter to secure the Starlink dish. Includes symbols indicating correct (check mark) and incorrect (X mark) tightening.]