ANALOG DEVICE Precision Narrow Bandwidth Signal Chains User Guide

User Guide for ANALOG DEVICE models including: Precision Narrow Bandwidth Signal Chains, Bandwidth Signal Chains, Signal Chains, Narrow Bandwidth, Bandwidth

Power Solutions for PTP Signal Chain Platforms

Precision Narrow Bandwidth - Fully Integrated Voltage and Current Measurement Density and Latency Optimized Sensor Ready

Analog Devices Inc.

密度とレイテンシーを最適化したセンサ対応

高精度狭帯域幅 - Analog Devices | DigiKey

Density and Latency Optimized Sensor Ready

Precision Narrow Bandwidth Signal Chains | Analog Devices

File Info : application/pdf, 5 Pages, 368.29KB

fully-integrated-density-latency-optimized

POWER SOLUTIONS FOR PRECISION TECHNOLOGY SIGNAL CHAINS
PRECISION NARROW BANDWIDTH Fully Integrated Voltage and Current Measurement
Density and Latency Optimized Sensor Ready
Rev. 0 | Jan. 2022
©2022 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners.
1

USER GUIDE

Power Solutions for Precision Technology Signal Chains

This document is interactive. You can click on any underlined text to navigate through the document.

For the resources:

For the individual pages:

Left-click the Parts Guide and Power Requirements to go through the list of power devices and other references.

Left-click the specific signal chain to go through its respective block diagram or power tree.

The Power Components are listed on the Appendix, and you may click on the part to go through its product page online.

APPENDIX
Isolated Multichannel

Parts Guide Power Requirements

USER GUIDE

Power Solutions for Precision Technology Signal Chains
Precision Narrow Bandwidth
Fully Integrated Voltage and Current Measurement
Density and Latency Optimized Sensor Ready

APPENDIX

Power Solutions for Precision Technology Signal Chains

Precision Narrow Bandwidth

Isolated Multichannel

Fully Integrated Voltage and Current Measurement
Density and Latency Optimized Sensor Ready

PART # LT3471 LT8606 LT8570 LT3999 ADP7118

DESCRIPTION Dual 1.3A, 1.2MHz Boost/Inverter in 3mm ×3mm DFN 42V, 350mA Synchronous Step-Down Regulator with 2.5A Quiescent Current Boost/SEPIC/Inverting DC/DC Converter with 65V Switch, Soft-Start and Sync. Low Noise, 1A, 1MHz Push-Pull DC/DC Driver with Duty Cycle Control 20V, 200mA, Low Noise, CMOS LDO Linear Regulator

APPENDIX
Isolated Multichannel

Power Solutions for Precision Technology Signal Chains

Precision Narrow Bandwidth

Fully Integrated Voltage and Current Measurement
Density and Latency Optimized Sensor Ready

POWER REQUIREMENTS

PARAMETER Supply Voltage

ADC

Isolation

LTC2358-18

ADN4624

VCC

VEE

VDD

OVDD

VDD1

VDD2

-15

2.5

1.8

Supply Current

9.8

-9.8

2.6

175

PSRR (100kHz)

110

130

Note 1: The supply currents indicated are the maximum quiescent current of the supply rails. For overall full load or short circuit current specifications, refer to the datasheets of the signal chain components. Note 2: The supply voltages indicated are the values for typical applications. Note 3: Consult the corresponding datasheets for details on power dissipation if needed. Note 4: The actual supply current requirement shall be multiplied depending on the number of channels on the signal chain.
5

References

Microsoft PowerPoint for Microsoft 365