User Manual for GIANT models including: FLOORLAMPBLE, 2A8UJ-FLOORLAMPBLE, 2A8UJFLOORLAMPBLE, Bluetooth RGBICW Floor Lamp, Bluetooth RGBICW, Floor Lamp, Lamp
SHENZHEN GIANT LIGHTING CO., LTD FLOORLAMPBLE BLUETOOTH RGBICW FLOOR LAMP 2A8UJ-FLOORLAMPBLE 2A8UJFLOORLAMPBLE floorlampble
Bluetooth RGBICW Floor Lamp Congratulations! You've purchased the Bluetooth RGBICW floor lamp. Please read the user manual and warnings carefully and keep it for future reference. Correct installation is required, please follow the instruction step by step. After installation, this Bluetooth RGBICW floor lamp can be controlled by App or touchsensitive button on the lamp. Male connector Metal Lamp pole C 2 Metal Lamp pole B1 B2 Female connector A Insert the male connector of B to the female connector of A,then insert C in the same way fix it with the screw Bluetooth RGBICW Short touch to switch colors, 6 RGBICW color modes. Short touch to switch colors, 6 RGBICW color modes. Pair the RGBICW floor lamp to "Smart Life" App Pair the RGBICW floor lamp to "Smart Life" App. RGBICW Make sure the Bluetooth of phone is open. And keep the device close to phone. Step one: Open the Bluetooth function of phone and keep the device close to phone. Make sure the device is in pairing mode, the floor lamp will blink in white. Step two: Open the smart life APP, Click the "+" on the right corner to add device. Step three: The app will scan and find the device, click "Add". Step four: Click "+" to star pairing. Step five: Then the floor lamp will be added successfully. Click Done to homepage. Homepage APP functions: Color mode Music mode Dynamic mode DIY mode Functions of RF remoter controller Demo mode: 15 dynamic modes switch automatically Dynamic mode: 15 dynamic modes change. Mode+/- Speed setting: In music or dynamic mode, speed+/- Short touch: On Long touch 5s: Reset to pairing mode Brightness+/- Timer 1H/2H/3H Color setting: 8 colors. Color switch Music mode: Music +/Lock and unlock the remote controller Bluetooth RGBICW floor lamp Digital RGB+ warm white Digital RGB + warm white, total 72 LEDs APP/Touch/RF Remoter controller RGBICW FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications cations to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.Adobe PDF library 15.00 Adobe Illustrator 25.0 (Macintosh)