Instructions for SOLIGHT models including: WO798-1-B LED Lighting with Remote Control, WO798-1-B, LED Lighting with Remote Control, Lighting with Remote Control, with Remote Control, Remote Control, Control
Solight LED osvětlení s dálkový ovladačem, 36W, 2300lm, 30cm, změna chromatičnosti, stmívatelné, černá | SOLIGHT
Iluminare LED Solight cu telecomandă, 36W, 2300lm, Ø30cm, schimbare de culoare, reglabil, negru [WO798-1-B] electronice ieftine de Solight
Solight LED rasvjeta s daljinskim upravljačem, 36W, 2300lm, Ø30cm, promjena boje, prigušiva, crna [WO798-1-B] jeftine marke elektronike Solight
EN Instructions for use of light panel WO798-1-B Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this appliance and always observe the electrical appliance usage guidelines. Do not hang or cover the luminaire with anything. Keep the instruction manual carefully. Installation may only be carried out by a qualified worker qualified in accordance with Decree No 50/1978 Coll., as amended, at least a worker who is knowledgeable in accordance with § 5 of Decree No 50/1978 Coll., as amended. TECHNICAL PARAMETERS Operating voltage Consumption Dimensions IP Coverage Illumination angle Chromaticity temperature Luminous flux 220-240V AC 36W - 4000K, 20W - 3000K and 6000K 300 x 70 mm IP20 120° 3000K/4000K/6000K 2300lm - 4000K, 1200lm - 3000K and 6000K PACKAGING CONTENT 1x 2x 1. Turn on 2. Turn off 1 2 3. Change colour temperature (-) 12 4. Change colour temperature (+) 3 5 5. Increase brightness 6. Decrease brightness 6 4 7. Brightness to 50% 7 8 8. Brightness to 100% 9. Color temperature change 9 10 10. Switches off after 60 seconds 11. Night mode (brightness 20%) 12. Pairing button 11 INSTALLATION Disconnect the power supply before installation. 1. Insert the dowels into the pre-drilled holes. 2. Thread the power cable through the holder and screw the holder in place. 3. Thread the power cable through the hole in the luminaire. 4. Screw the luminaire to the bracket. 5. Connect the power cord to the terminal block and make sure the wiring is correct. 6. Attach the front cover. 7. Switch on the power supply. Note: Use caution when removing the front cover. Press the cover down on one side and lift it up on the other side to remove. You can use a blunt object such as a knife. Note: To pair the remote control with the light, switch the light off from the mains for approx. 15sec and when the light comes back on, hold the centre button with the WiFi symbol on the remote control (point 12 in the description of the remote control). After successful pairing, the light will flash twice. . The light source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed of in a designated place. This product contains a light source that for design reasons cannot be removed for verification and therefore the entire product is considered a light source. The power cord cannot be replaced if damaged, the unit must no longer be used. We are not liable for any damage caused by improper use. Producer: Solight Holding, s.r.o., Na Brn 1972, Hradec Králové 500 06, Ceská republika.Adobe PDF Library 23.6.156