Agrowtek Inc. :: Grow Controls for Greenhouses, Hydroponics & Indoor Growing
Instruction Manual for AGROWtEK models including: SXL-D-RX1 Drain Control System with Outlet Relay, SXL-D-RX1, Drain Control System with Outlet Relay, Control System with Outlet Relay, Outlet Relay
File Info : application/pdf, 1 Pages, 541.72KB
DocumentDocumentAGROWtEK Technology to Help You Grow SXL-D-RX1 Drain Control System with Outlet Relay Drain Control | High - Low Sensing Electronic optical "liquid level control system" includes two liquid sensors for high and low drain control of water with a RX1 outlet relay. Simply install the sensors and wire the kit according to the instructions below. The system automatically drains the tank by turning the outlet. No other control system is required. Made in How It Works USA The high-level sensor turns on the outlet to operate until liquid drains below the low-level sensor. Installation 1. Mark the tank wall at the desired high and low points. 2. Thick Wall: Drill 7/16" holes and tap with a 1/4 NPT tap. Thread sensor in hole. Thin Wall (3/16" & under): Drill a 17/32" hole, place o-ring on sensor & nut inside tank. 3. Tighten sensor and check for leaks. Use teflon tape for tapped holes. 4. Make electrical connections according to the diagrams below. Wiring Diagram WARNING: DO NOT USE these products as safety or emergency stop devices or in any other application where failure of the product could result in personal injury. Failure to comply with these instructions could result in death or serious injury. DRAIN NOTES: AGROWtEK Technology to Help You Grow RX1 1. Check sensor type marking through hex head. 2. Use o-ring & nut in thin, flat-wall tanks. Locate o-ring between sensor hex head and outside tank wall. 3. Customer must provide two-conductor wire cable (minimum 22AWG) to connect valve to sensors. Relay Outlet © Agrowtek Inc. | www.agrowtek.com MADE IN U.S.A. + - 24Vdc SXL-1 Wet-ON Marking: "Wet" V+ GND OUT V+ GND OUT SXL-1X Wet-ON Latch Marking: "xWet" High Level Sensor Turn ON (Open) Low Level Sensor Turn OFF (Close) Sensor/LED Status Status High Sensor Low Sensor Empty Sensor OFF, LED OFF Sensor OFF, LED Flash/10sec Mid-Level Sensor OFF, LED Flash/10sec Sensor ON, LED ON High Sensor ON, LED ON Sensor ON, LED ON Draining Sensor ON, LED ON FlashOFF/10sec Sensor ON, LED ON Specifications Kits Voltage Input: Output Current: Current Consumption: Mounting Thread: Hex Size: Body Material: Temperature Range: Wire Gauge: 5-24Vdc Max 1A (sourcing) 20mA per sensor 1/4" NPT 3/4" (19mm) Polysulphone -20 to 80°C (non-freezing) 26 - 16 AWG SXL-D-RX1 120V Outlet Relay Drain Mode Optical Level Sensors See SXL and RX1 manuals or contact Agrowtek Inc. for warranty terms and conditions. Individual Sensors SXL - 1 1: Low Drain Sensor 1B: High Drain Sensor © Agrowtek Inc. | www.agrowtek.com | Technology to Help You GrowTM