Side-By-Side Water and Ice Dispensing Guide & Pizza Pocket Assembly

Water and Ice Dispensing Guide

This guide provides instructions for operating the water and ice dispenser on your side-by-side refrigerator.

Dispenser Component Overview

The dispenser features the following components:

A: Water dispenser paddle
B: Water dispenser spout
C: Ice dispenser paddle
D: Ice guide

To Dispense Water

Press a sturdy glass against the water dispenser lever. Hold the glass close to the water dispenser spout to ensure that the water dispenses directly into the glass.
Remove the glass to stop dispensing.

IMPORTANT: The small tray at the bottom of the dispenser is designed to catch small spills and allow for easy cleaning. There is no drain in the tray. To empty and clean the tray, push down on the back of the removable tray and pull it out.

To Dispense Ice

Ice dispenses from the ice maker storage bin in the freezer when the dispenser paddle is pressed. For instructions on turning off the ice maker, refer to the "Ice Maker and Storage Bin" section in your Owner's Manual.

Before dispensing ice, select your preferred ice type (crushed or cubed) by pressing the "Ice Type" button. The display screen will indicate which type of ice is selected.

Crushed Ice: For crushed ice, cubes are crushed before dispensing. This may cause a slight delay. Noise from the ice crusher is normal, and ice piece sizes may vary. When switching from crushed to cubed ice, a few ounces of crushed ice may dispense with the first cubes.

Make sure the desired type of ice is selected.
WARNING: Cut Hazard
Use a sturdy glass when dispensing ice. Failure to do so can result in cuts.

Press a sturdy glass against the dispenser lever. Hold the glass close to the ice guide to ensure that the ice dispenses into the glass.
IMPORTANT: You do not need to apply a lot of pressure to the paddle to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.
Remove the glass to stop dispensing.

Pizza Pocket Assembly

This section provides instructions for assembling and using the pizza pocket accessory.

Assembly Instructions

Refer to the diagrams for visual guidance.

Diagram Description: An illustration shows the interior of a side-by-side refrigerator with an arrow indicating the "Pizza pocket location".

Insert three hooks on part "A" into their corresponding slots on part "B". Ensure the hooks fit into the side opposite to the upper lip.
Assemble parts A and B at a 90° angle. NOTE: Do not exceed a 90° angle.
Place the assembly onto the studs on the liner wall.