Installation Guide for SNR models including: SNR-S5210X-8F, SNR-S5210X-24FX, SNR-S5210X-8F Managed L2 Plus Ethernet Switch, Managed L2 Plus Ethernet Switch, L2 Plus Ethernet Switch, Ethernet Switch

SNR-S5210X-8F

Dec 13, 2024 — Port LEDs. Off. No link on port. Green. The port has a valid link. Green (Blink). Blinking indicates activity on port. 5 xe1-8. 1/10GBase-X SFP ports.


File Info : application/pdf, 4 Pages, 1.65MB

PDF preview unavailable. Download the PDF instead.

SNR-S5210X-8F - Quick Installation Guide
SNR-S5210X-8F
Managed L2+ Ethernet Switch
Quick Install Guide

SNR-S5210X-8F

Quick Install Guide

SNR-S5210X-24FX Quick Install Guide
This guide describes the steps of installing the switch, including the basic introduction to the product, the basic installation steps, etc.

1. Front and back panels description

7

 Item

Description

1 ~100-240V; 50/60Hz The AC power socket, AC rated voltage range: 100-240V AC 50/60 Hz

2 Grounding

The Grounding screw

Switch status LED

DIAG

Green

System is starting or abnormal

Green (Blink)

System works normally

3

PRW1 - AC power LED, PWR2 - DC power LED

PWR1, PWR2

Green

Power is on

Off

Power is off or error

Port LEDs

4 xe1-8

Off Green

No link on port The port has a valid link

Green (Blink)

Blinking indicates activity on port

5 xe1-8

1/10GBase-X SFP+ ports

6 CONSOLE

Console port

7 USB

USB port

SNR-S5210X-8F

Quick Install Guide

2. Switch installation
Before installation, take ECD-preventive measures, such as wearing the ESD-preventive gloves or a wrist strap.
2.1 Install the device in a 19" cabinet
Fix the rack mount brackets.

Fix the captive nuts, and install the device in a cabinet. Attention: leave more than 1U space between the devices for proper heat dissipation.

2.2 Install the device on a worktable
Stick the rubber gasket, and Install the device on a worktable.
2.3 Connect the PGND cable and power cable
Connect the switch with the PC NIC interface. Power on the switch.

Connect the AC power cable.

SNR-S5210X-8F

Quick Install Guide

3. Access to initial switch configuration

3.1 Access to the switch via console port

Connect console cable to switch via RJ-45 connector and another side to RS-232 port of the PC. Settings of the COM-port are below:

Parameter Bitrate Databits Parity StopBits FlowControl

Value 115200 8 None 1 None

Use default username admin and password admin to access the switch.
3.2 Access to the switch via Ethernet port

Connect the switch with the PC NIC interface. Power on the switch. Check whether the IP-address of the computer is within this network segment: 192.168.1.xxx (``xxx'' ranges 2~254), for example, 192.168.1.100. Open telnet connection to address 192.168.1.1.

Parameter Switch default IP-address Default username Default password

Value 192.168.1.1 admin admin

4. Technical support
NAG service and technical support center: NAG LLC Address: Office M-03, Al Garhoud Business center Building. UAE, Dubai Website: snr.global Technical support portal: snr.support Tel: +971 0 42599967



References

Adobe InDesign 19.0 (Windows) Adobe PDF Library 17.0