Ryobi 18 Volt Hand Vac with Mini Beater Bar

Important Safety Instructions

SAVE THESE INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:

WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury.

READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

WARNING: To reduce the risk of electric shock do not expose to rain. Store indoors.

• Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, loose clothing, fingers, and all parts of the body and clothing, away from openings and moving parts. Loose clothes, jewelry, or long hair can be caught in internal moving parts.
• Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the hand vac in unexpected situations. Do not use on a ladder or unstable support.
• Use safety equipment. Dust mask must be used for appropriate conditions.
• Do not allow children to operate the product or play with the product as a toy. Close attention is necessary when used by or near children.
• Use this product ONLY for its intended use as described in this manual. Use only the attachments recommended in this manual.
• If the product is not working properly, has been dropped, damaged, left outdoors, or dropped into water, return to your nearest service center.
• Do not handle charger plug or product with wet hands.
• Do not put any objects in ventilation openings. Do not use with any opening blocked. Keep openings free of dust, lint, hair, and anything that may reduce air flow.
• NEVER vacuum materials that are burning or smoking, such as hot coals, cigarette butts, matches, burning or smoking ashes, etc.
• DO NOT use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
• Use extra care when using on stairs.
• This unit is for dry vacuuming only. Do not use to clean up liquids.
• Do not use without dust bowl and filter in place.
• Do not incinerate this appliance even if it is severely damaged. The batteries can explode in a fire.
• The product does not have to be plugged into an electrical outlet, therefore it is always in operating condition. Be aware of possible hazards when using the product or when changing accessories.
• Remove battery when the vacuum is not in use and before servicing.
• Use this product only with batteries and chargers listed in tool/appliance/battery pack/charger correlation supplement 987000-432.
• Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
• Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire.
• When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns, or a fire.
• Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.
• Do not use a battery pack or power tool that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
• Do not modify or attempt to repair a power tool or battery pack that has been damaged.
• To reduce the risk of serious personal injury, never use or expose battery pack or any cordless product in the presence of an open flame or temperature above 265°F. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.
• Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the product. Carrying battery products with your finger on the switch or energizing battery products that have the switch on invites accidents.
• Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the battery may cause irritation or burns.
• Do not charge battery tool in a damp or wet location.
• Do not use, store, or charge battery packs or products in locations where the temperature is less than 50°F or more than 100°F. Do not store outside or in vehicles.
• Protect your lungs. Wear a face or dust mask if the operation is dusty. Following this rule will reduce the risk of serious personal injury.
• Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the hand vac's operation. If damaged, have the product serviced before using. Many accidents are caused by poorly maintained products.
• Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one product may create a risk of injury when used on another product.
• Do not let gasoline, oils, petroleum-based products, etc., come in contact with plastic parts. They contain chemicals that can damage, weaken, or destroy plastic.
• Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure that the safety of the product is maintained.
• This product contains no serviceable parts.
• Save these instructions. Refer to them frequently and use them to instruct others who may use this hand vac. If you loan someone this hand vac, loan them these instructions also.

Symbols

The following signal words and meanings are intended to explain the levels of risk associated with this product.

SYMBOL	SIGNAL	MEANING
Safety Alert Symbol	DANGER:	Indicates a hazardous situation, which, if not avoided, will result in death or serious injury.
Warning Symbol	WARNING:	Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
Caution Symbol	CAUTION:	Indicates a hazardous situation, that, if not avoided, may result in minor or moderate injury.
NOTICE:	(Without Safety Alert Symbol) Indicates information considered important, but not related to a potential injury (e.g. messages relating to property damage).

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer.

SYMBOL	NAME	DESIGNATION/EXPLANATION
Safety Alert Icon	Safety Alert	Indicates a potential personal injury hazard.
Read Operator's Manual Icon	Read Operator's Manual	To reduce the risk of injury, user must read and understand operator's manual before using this product.
Wet Conditions Alert Icon	Wet Conditions Alert	Do not expose to rain or use in damp locations.
Long Hair Icon	Long Hair	Risk of long hair being drawn into air inlet.
Recycle Symbol Icon	Recycle Symbol	This product uses lithium-ion (Li-ion) batteries. Local, state or federal laws may prohibit disposal of batteries in ordinary trash. Consult your local waste authority for information regarding available recycling and/or disposal options.
V	Volts	Voltage
min	Minutes	Time
=	Direct Current	Type or a characteristic of current
no	No Load Speed	Rotational speed, at no load
.../min	Per Minute	Revolutions, strokes, surface speed, orbits etc., per minute

This is a "household type" product which means it is intended for household use.

Assembly

WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury.

WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

If any parts are damaged or missing, please call 1-800-525-2579 for assistance.

Operation

WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING: Always remove battery pack from the tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.

WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

APPLICATIONS

You may use this product for the following purpose:

• Light-duty vacuuming of dry surfaces

INSTALLING/REMOVING BATTERY PACK

See Figure 1, page 7.

• Insert the battery pack into the battery port.
• Make sure the latches on each side of the battery pack snap into place and that the battery pack is secured in the hand vac before beginning operation.
• Locate the latches on the side of the battery pack and depress both sides to release the battery pack from the hand vac.

For complete charging instructions, see the operator's manuals for your battery pack and charger.

STARTING/STOPPING THE VACUUM

See Figure 2, page 7.

• To start the vacuum: Depress the ON/OFF switch to turn the vacuum on.
• To stop the vacuum: Depress the ON/OFF switch to turn the vacuum off.

INSTALLING ACCESSORIES

See Figure 3, page 7.

• Install only accessories designed for use with this vacuum.
• Remove the battery pack.
• Insert the accessory onto the nozzle.
• Push the accessory securely into place.
• When not in use, remove and store the accessory.

USING THE MINI BEATER BAR

See Figure 4, page 7.

The mini beater bar can connect directly to the vacuum for cleaning upholstery and stairs.

To connect:

• Switch off unit and remove the battery pack.
• Align the pins on the mini beater bar with the receptacle in the vacuum.
• Press into place.
• Replace battery pack.

To remove:

• Switch off unit and remove the battery pack.
• Pull to remove.

REMOVING/REATTACHING THE DUST BOWL

See Figures 5 - 7, page 8.

The dust bowl should be checked, emptied, and cleaned periodically for maximum dust collection.

To empty:

• Remove the battery pack.
• Press the locking tab on the bottom of the bowl to release the spring loaded door.
• Hold unit over waste receptacle.
• Shake lightly or tap sides to dislodge debris.
• Close door, pressing firmly until lock button engages.

To remove:

• Remove the battery pack.
• Depress the release button located on the nozzle. Pull the dust bowl down and out.

To reattach:

• Position the two sections as shown.
• Align the slot on the bottom of the dust bowl and the eject tab at the front of the dust bowl.
• NOTE: Make sure tab and slot are aligned correctly before securing the dust bowl.
• Press the dust bowl into place until you hear a click.

Maintenance

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which could result in serious personal injury.

CLEANING/REPLACING THE FILTER

See Figure 8, page 8.

• Remove the battery pack.
• Depress the release button located on the nozzle.
• Remove dust bowl, filter housing, and filter from vacuum.
• Remove filter housing and filter from dust bowl.
• Turn filter counterclockwise and remove it from filter housing.
• NOTE: To reassemble, insert filter into filter housing and turn clockwise to lock into place.
• Shake or lightly brush any dust or dirt off the filter.
• Shake or lightly brush any dust off the filter housing. Wash if necessary.
• Empty the dust bowl; wash if necessary. Before reattaching to the hand vac, make sure all pieces are completely dry.
• NOTE: Allow 24 hours for parts to dry completely.
• When purchasing replacement filter, request recommended part number 542363003.

REMOVING THE ROLLER BRUSHES FOR CLEANING

See Figure 9, page 8.

The roller brush is located inside the the mini beater bar. The roller brush has a tool-free end cap, allowing it to be easily removed for cleaning.

To remove:

• Remove the battery pack.
• Insert a coin into the slot on the end of the roller brush. Rotate the end cap approximately 1/4 in. counterclockwise to unlock the roller brush.
• Slide the brush to release the cap and pull the brush from the mini beater bar assembly.
• NOTE: Use scissors to remove any threads or hair wrapped around the roller brush using the scissor grooves.

To reattach:

• Insert the roller brush into the mini beater bar assembly.
• Align the tabs on the cap to the notches on the assembly and firmly press the cap into place.
• NOTE: Make sure the opposite end of the roller brush is aligned to the drive spindle when pressing the cap into the assembly housing.
• Turn the end cap 1/4 in. clockwise with coin to lock into place.

NOTE: ILLUSTRATIONS START ON PAGE 7 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

Contact Information

To request service, purchase replacement parts, locate an Authorized Service Center or obtain Customer or Technical Support:

Visit www.ryobitools.com or call 1-800-525-2579

If any parts or accessories are damaged or missing, do not return this product to the store. Call 1-800-525-2579 for immediate service.

Please obtain your model and serial number from the product data plate.

This product is covered under a 3-year limited Warranty. Proof of purchase is required.

RYOBI is a trademark of Ryobi Limited and is used pursuant to a license granted by Ryobi Limited.

TTI CONSUMER POWER TOOLS, INC.

P.O. Box 1288, Anderson, SC 29622 • Phone 1-800-525-2579

www.ryobitools.com