Instruction Manual for Aprilaire models including: 5822, 5822 Dehumidifier Hanging Kit, Dehumidifier Hanging Kit, Hanging Kit

aprilaire-5822-dehumidifier-hanging-kit-installation-guide

Aprilaire Dehumidifier Hanging Kit, Part No. 5822 | GasExperts

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 1 Pages, 227.17KB

5822 Dehumidifier Hanging Kit
Installation Instructions

CAUTION
1. Hanging kit is designed for attic and crawl space residential use only.
2. 200 lb maximum total load. 3. Not intended for overhead use in an
occupied space.

PARTS INCLUDED: 1. Ratchet rope (4) 2. Brackets (4) 3. Eye bolts (4)

TOOLS REQUIRED: · Tape measure · Level · Screw driver · Drill with 13/64"
(max) bit

INSTALLING BRACKETS

The brackets are designed to attach to the dehumidifier using the leveling feet.
1. Tip the dehumidifier enough to remove one foot.
2. Slide the foot through the large hole in the bracket.
3. Screw the foot back into the base of the dehumidifier. Fully tighten foot. See FIGURE 1.
4. Repeat with remaining feet.

FIGURE 1

INSTALLING EYE BOLTS
Eye bolts should be screwed into floor joists horizontally. 1. Measure the distance between the centers
of the clip mounting holes in bracket, along the length of the dehumidifier. 2. Use that dimension to determine eye bolt spacing. Eye bolts should be installed horizontally. 3. Use a drill and 13/64" (max) drill bit to drill pilot holes. 4. Use a screw driver to turn in eye bolts until no threads are visible. See FIGURE 2.
FIGURE 2

INSTALLING RATCHET ROPES

1. Clip the carabiners connected to the ratchet to the eye bolts. See FIGURE 3. 2. Use the release lever to lengthen the rope to the hanging bracket. 3. Clip the carabiners on the knotted end of the rope to the hanging brackets. See FIGURE 4. 4. Pull down on the free end to take out any slack in the hanging rope. 5. To raise unit, simultaneously pull up on the rope attached to the brackets or support the
weight of the corner being adjusted, and pull down on the free end of rope. 6. Make 6" or less vertical adjustments on each rope until unit is at desired height. 7. Use a level to make sure unit is level in both front to back and side to side directions.

FIGURE 3

FIGURE 4

RELEASE LEVER

AprilairePartners.com Printed in USA ©2019 Aprilaire ­ Division of Research Products Corporation 10013748B2208410A3.19

P.O. Box 1467 Madison, WI 53701-1467 800.334.6011 F: 608.257.4357



References

• AprilAire Partners