Anchor Straps for BeSafe Stretch

Product Overview

This accessory set, the Anchor Straps for BeSafe Stretch, is designed for use with specific BeSafe child car seats. It is a crash-tested product intended for vehicles where anchor points for lower tether straps are not available.

Installation Guide

For detailed installation instructions, please refer to the relevant user manual. The following outlines the general methods:

Option 1: Installation on the Back Seat

Objective: To attach the anchor strap to the vehicle's seat rails for rear seat installation.

Steps:

1. Guide the anchor strap beneath the rail of the front seat.
2. Bring the metal end of the strap through the loop opening that creates the shortest anchor strap.
3. Pull the strap tight.
4. Repeat the process on the other rail.
5. Ensure that both rails are securely fixed to the vehicle.

Note: If your vehicle does not support this method for back seat installation, please contact your retailer or BeSafe directly for advice on alternative methods.

Option 2: Installation on the Front Seat

Objective: To combine two anchor straps into one long strap for front seat installation.

Steps:

1. Combine the two anchor straps: Bring the metal end of strap 1 through the loop at the end of strap 2, and then through the loop at the end of strap 1.
2. Pull the straps tight together to secure them.
3. Place the center of the combined strap onto the front seat.
4. Guide both ends around the backrest to the back of the seat on each side.
5. From the back, guide both ends underneath the front seat to the front of the vehicle.

Warranty

For warranty details, please visit www.besafe.com.