Sprayer-Spreaders for Lawn Care Applicators | Steel Green Manufacturing
Instruction Manual for STEEL GREEN MANUFACTURING models including: SG36, SG36 Hydraulic Oil Change, Hydraulic Oil Change, Oil Change, Change
File Info : application/pdf, 4 Pages, 821.81KB
DocumentDocumentINSTRUCTION MANUAL HYDRAULIC OIL CHANGE Models: SG36, SG42, SG46, & SG52 HYDRAULIC OIL CHANGE INSTRUCTIONS Change hydraulic oil and filter every 500 hours with Synthetic Plus Engine Oil 10W-30. API service classification SN plus, Resource conserving; ILSAC GF-5. STEP 1: Remove the knee pad to access the hydraulic oil reservoir. STEP 2: · Loosen and remove the cap from the hydraulic oil res- ervoir. · Disconnect the rear hoses from the hydraulic pumps, place the hoses over a proper container draining the hydraulic oil. · Once the oil has been drained, reconnect the hoses to the pumps. NOTE: To drain the most oil out as possible, you can also remove the rear tires and disconnect the hoses from the wheel motors to drain the oil at the lowest point. 2 HYDRAULIC OIL CHANGE INSTRUCTIONS STEP 3: Remove and replace the hydraulic oil filter. STEP 4: · Refill the hydraulic oil to the full line. with 5w50 full synthetic. · Jack up the rear of the machine so the rear tires are off of the ground. · Start and run the machine in forward and reverse to cycle the hydraulic oil back through the system, you will see the oil level drop in the reservoir. · Ounce the oil level has dropped, refill the reservoir to the full line and reinstall the cap. FULL LINE . 3 MADE IN THE USA Steel Green Mfg. 824 S State Road 39 Lebanon, IN 46052 (765)-481-2890 www.steelgreenmfg.com MANUAL PART NO. SGM-027 MANUAL REV. C DESCRIPTION SG HYDRAULIC OIL CHANGE 4