Samsung DW8700B Built-in Dishwasher Installation Guide
Model: DW8700B
Document Revision: DD68-00094E-04
Required Tools
- Electric Driver
- Drill (⌀ 2.0mm)
- Wrench (22mm)
- Torx Driver (T20)
- Phillips Head Screwdriver (+)
- Nipper / Wire Cutter
- Check Valve (Optional, for applicable models)
- Safety Glasses (Recommended)
- Gloves (Optional, for applicable models)
Required Hardware
- Screw (⌀ 4 x 12mm)
- Screw (⌀ 4 x 16mm)
- Screw (⌀ 4 x 43mm)
Custom Panel Mounting
This section details the requirements for attaching a custom front panel to the dishwasher door.
- Panel Weight: The custom panel should weigh between 4 kg and 9 kg. The maximum weight for the panel is specified as 9 kg.
- Panel Thickness: The maximum allowable thickness for the custom panel is 20 mm.
- Attachment Method: Use the Torx T20 screwdriver for securing the panel. The diagram indicates using two screws (labeled 'B' in the original document) for this purpose. A clearance of 100-200 mm is shown, likely for alignment or access during installation.
Cabinet and Unit Dimensions
Specifications for unit installation within cabinetry.
| Specification | Value |
|---|---|
| Unit Height Range | 815 - 860 mm |
| Cabinet Opening Height Range | 820 - 865 mm |
| Cabinet Opening Width | Approximately 594 mm (based on diagram elements) |
| Cabinet Opening Depth | Approximately 555 mm (based on diagram elements) |
| Mounting Point Dimensions | Various dimensions indicated: 552 mm, 595 mm, 100 mm, 50 mm, 125 mm, 55 mm, 91 mm, 457 mm. These likely relate to bracket placement or cabinet cutouts. |
| Additional Clearance | 30 mm |
Installation Adjustments and Clearances
Details on leveling, alignment, and necessary clearances.
- Height Adjustment: The unit can be leveled using adjustable feet, with a range of 0-45 mm for each side.
- Angle: A 30° angle is indicated, possibly related to screw insertion or component alignment.
- Door Opening Clearance: Ensure a maximum clearance of 80 cm for the dishwasher door to open fully.
- Normal Operation: The diagram shows a "Normal" setting, implying standard operating conditions after installation.
General Installation Steps
A summary of the installation process, referencing visual cues from the original document.
- Prepare Cabinet and Unit: Ensure the cabinet opening meets the specified dimensions and clearances.
- Attach Custom Panel: Mount the custom front panel to the dishwasher door using the specified screws (e.g., ⌀ 4 x 43mm) and Torx T20 driver, respecting the panel thickness limit (max 20mm). Use two screws as indicated.
- Position and Level Unit: Slide the dishwasher into the cabinet opening. Adjust the leveling feet to achieve the correct height (815-860 mm) and ensure the unit is perfectly level.
- Secure Unit: Fasten the dishwasher to the cabinet structure using appropriate screws (e.g., ⌀ 4 x 16mm) through the mounting points.
- Final Checks: Verify all connections, panel fit, and unit stability. Ensure all required clearances are maintained.
Note: Specific labels like '1 A', '11 A', 'C', '3', '8', '9' in the source document refer to detailed visual instructions for specific components or steps not fully elaborated here.
