Installation
Recommendations below are commonly accepted industry practices.
- Apply a premium grade thin-set mortar using a 5mm (3/16 in) V-notch trowel.
- Set tiles and apply pressure or tap the surfaces with a rubber grout float to ensure all tiles are bonded and aligned properly. Use a level periodically to check setting heights. Maintain a consistent grout joint by using spacers between sheets.
- After 24 hours, mix and apply grout. UNSANDED GROUT is suggested for glossy/ polished/ honed finish to avoid scratching of the surface. SANDED GROUT is suggested for matte finish surfaces. Grout selection should be made with considerations to surface finish, grout joint width, technical benefits of available grout options, as well as install location.
- Clean all excess grout immediately with a damp sponge. Follow grout manufacturer's recommendations for removing grout haze.
- After 12 hours, polish off any remaining haze with a dry cloth or towel.
Cutting
Wear a respirator and safety glasses when cutting, grinding, or polishing. Use wet cutting methods and do not dry cut.
Care and Cleaning
Spills should be wiped immediately and not allowed to sit on the tile surface. Use a soft cloth or sponge with warm water to clean tile.
Installation Steps Visuals
Image 1: A gloved hand using a V-notch trowel to apply thin-set mortar onto a surface.
Image 2: Porcelain mosaic tiles being carefully laid and aligned on a surface.
Image 3: A gloved hand using a rubber grout float to spread grout over installed tiles.
Image 4: A gloved hand using a large, damp sponge to wipe excess grout from the tile surface.
Image 5: A gloved hand using a white cloth to polish the tile surface, removing any remaining grout haze.
Warning
Before tile installation, please ensure enough cartons for the entire project are obtained of same tonality and lot code. The product should be inspected for any visual defects prior to installation. For best results in any tile project, tiles must be blended from various cartons to achieve an aesthetically consistent blend. Claims for visual defects will not be accepted after installation.
Warranty
Product is warranted as per our Warranty Statement for product replacement only. The warranty does not cover costs of labor, and installation.
Important: Installation Instructions
We recommend wet cutting or the score and snap method during the installation process. Improper installation techniques could expose installer to harmful silica dust.
Do not dry cut product using power tools during the installation process. Using dry cutting methods could present a risk of acute lung injury. If adequate ventilation cannot be achieved, wear a mask or respirator. For more information, see the SDS at www.anatolia.com.
