Installation Guide for DAKTRONICS models including: NPN-4600 Series Border, NPN-4600 Series, Border
Nov 8, 2024 — Refer to the bill of materials for part numbers and to Figure 1 for a visual. Border Installation. Borders are attached either before the display is mounted ...
Nov 8, 2024 · There are six different border sizes for the NPN-4600 display series: one-, two-, three-, and four-panel-high borders and one- and two-panel- ...
File Info : application/pdf, 1 Pages, 132.99KB
DocumentDocumentNPN-4600 Series Border Installation Quick Guide Flat Border Tools Page 1 of 1 5. Bring the border into position. The holes should be oriented toward the front of the display to align with the threaded holes in the panels. Refer to Figure 3. Part Part Description Flat-head bit or screwdriver Removes top alignment pins 3 mm hex key (Daktronics part Removes Top and Left side stitch bolt hardware number TH-5406561) Attaches borders 3 mm hex bit (TH-5406562) Attaches borders Part Identification There are six different border sizes for the NPN-4600 display series: one-, two-, three-, and four-panel-high borders and one- and two-panel-wide borders. The part numbers are etched into the metal on each border for identification purposes. Refer to the bill of materials for part numbers and to Figure 1 for a visual. Part number Figure 1: Flat Border Border Installation Borders are attached either before the display is mounted to the structure or after if site conditions allow for tool clearance around the mounted display. If the borders must be installed before the sections, only one-panel-high (0M-4804541) and two-panel-wide (0M-4804551) borders are available. Borders longer than one panel high must be installed after the display sections are mounted to the structure. 1. Remove the borders from its packaging. 1 Note: Be careful when handling the borders, do not set them onto rough surfaces to avoid scratching the paint. 3 2 2. Remove the top alignment pins from the top row of panels. Remove the M5 stitch bolt hardware on the top row and left-most side of the display. This hardware must be removed before final tile installation. Refer to Figure 2. 3. Select the correct border size according to the Shop Drawing. 4. Use a clean rag to wipe off the perimeter of the panel receiving the border. 2 1 3 Figure 3: Install Flat Border 6. Use a 3 mm hex key (TH-5406561) or 3 mm hex bit (TH-5406562) to attach the M5-0.8 x 12 mm machine screws (HC-5402741), fastening the border to the panel perimeter in all pre-punched hole locations on the border. Each panel has threaded holes for borders on all four sides. Refer to Figure 4 for the finished appearance. Note: When unthreading the stitch screw, push on the end of the screw with the 3mm hex key while turning. DD5544742 Rev 00 8 November 2024 1: Top alignment pins 2: Side interconnect hardware (M5 stitch bolt) 3: Top interconnect hardware (M5 stitch bolt) Figure 2: Prepare Panels Figure 4: Attached Flat Border 201 Daktronics Drive Brookings, SD 57006-5128 www.daktronics.com/support 800.325.8766