FOXX A67W & A67W Lite Smartphone User Manual and Safety Information

Introduction

Thank you for choosing a FOXXD product. Please follow the instructions when you begin using this product.

What's in the Box

The phone packaging box should contain the following items and accessories:

• Phone
• Charger
• USB Type-C cable
• Protective film (applied)
• Quick start guide

Product Safety Information

Important safety precautions for using your FOXX smartphone:

• Do not use while charging.
• Do not use while driving without a hands-free system.
• This device may emit a bright or flashing light.
• For body-worn operation, maintain a separation of 5 mm.
• Do not throw the phone into fire.
• Contains small parts that may pose a choking hazard.
• Avoid contact with magnets.
• This device may produce loud sound.
• To avoid possible hearing damage, do not listen at high volume levels for prolonged periods.
• Avoid extreme temperatures. High temperatures can shorten the lifespan of electronic devices, damage batteries, and warp or melt certain plastics.
• Avoid placing the phone in low-temperature environments. When the temperature rises, the phone may produce water vapor that can damage electronic circuits.
• Keep away from pacemakers and other personal medical devices.
• Avoid contact with liquids. Keep it dry.
• Turn off when instructed in hospitals and medical facilities.
• Do not attempt to disassemble your phone.
• Turn off when instructed in airports and on airplanes.
• Do not rely on this device for emergency communications.
• Turn off when in explosive environments.
• Use only approved accessories.
• Avoid placing the phone in dusty and dirty environments, as this can damage parts.
• Avoid placing the phone near a lit cigarette, open flame, or any heat source.
• Do not drop, knock, or shake the phone. Rough handling can damage internal circuit boards.
• Do not paint the phone. Paint may block earpieces, microphones, or other removable parts, rendering them inoperable.
• Use a clean, soft, and dry cloth to clean the camera and light sensor lenses. Do not use harmful chemicals or cleaning agents.
• Pacemaker manufacturers recommend maintaining a minimum separation of 5 mm between a mobile phone and a pacemaker to prevent potential interference. (In the US, this separation can be maintained at 10 mm between the user's body and the phone).
• Consult your doctor or the device manufacturer to determine if your phone's operation may interfere with your medical devices.
• Turn off your mobile phone or wireless devices when in a blasting area or an area with "two-way radios" or "electronic devices" to avoid interfering with blasting operations.
• There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to instructions.

Know Your Phone

Diagrammatic description of phone components:

• Camera Flash: Located on the front or back, used for illumination.
• Touchscreen: The primary display interface for interaction.
• Speaker/Earpiece: Located at the top, used for audio output during calls.
• USB Charging Port: Located at the bottom, for charging and data transfer.
• Camera: Main camera sensor, typically on the back.
• Earpiece: The speaker for listening during calls.
• Volume Keys: Buttons on the side to adjust audio volume.
• Power Key: Button on the side to turn the phone on/off or wake/sleep the screen.
• Microphone: Located at the bottom, for audio input.
• Speaker: Main audio output speaker, often at the bottom or front.

Key Functions:

• Power Key: Press and hold to turn on/off or restart the phone. Press briefly to activate or turn off the screen.
• Home Key: Tap to return to the home screen. Press and hold to open Google Assistant.
• Menu Key: Tap to view recently used applications.
• Back Key: Tap to return to the previous screen.
• Volume Keys: Press and hold to increase or decrease the volume.

Basic Operations

Installing SIM Card

Instructions for inserting a SIM card (and optionally a micro-SD card).

Note: Some applications may require a micro-SD card to function normally or store data. It is recommended to keep a micro-SD card installed and not remove or replace it randomly.

Installing Battery

Instructions for installing the battery.

Closing the Back Cover

Instructions for securing the back cover.

Basic Settings

Your service provider may have pre-set some device configurations, which you might not be able to change.

Display

• Brightness: Adjusts the screen brightness level.
• Lock Screen: Customize what is displayed on the lock screen.
• Screen Timeout: Sets the time before the screen goes to sleep when inactive.
• Appearance:
  • Dark Theme: Toggles dark background mode.
  • Font Size: Sets the system font size.
  • Screen Size: Sets the display size.
• Other Screen Controls:
  • Auto-rotate Screen: Enable or disable screen rotation by swiping.
  • Screensaver: Choose screensaver and when it starts.

System

• Languages & Input: Configure supported languages and input methods (on-screen or physical keyboard).
• Date & Time:
  • Set time automatically: Use network-provided date and time.
  • Time Zone: Use network-provided or location-based time zone.
  • Time Format: Choose between default local format or 24-hour format.

About Phone

View basic information such as device name, phone numbers, legal information, SIM status, memory/storage, operating system, IP address, uptime, build number, etc.

Technical Specifications

Note: The actual available storage space may be less than the internal memory due to the pre-loaded operating system and other pre-installed applications. Check your phone's available space.

FCC Information and Compliance

FCC Warning

15.19 Labeling requirements: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

15.21 Information to user: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

15.105 Information to the user: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Absorption Rate (SAR) Information

This device meets the government's requirements for exposure to radio waves. The guidelines are based on standards developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

FCC RF Exposure Information and Statement: The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This device was tested for typical body-worn operations with the back of the device kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an appropriate separation distance between the user's body and the back of the device. The use of belt clips, holsters, and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

SAR Declaration: The US SAR limit for smartphones is 1.6 W/kg averaged over 1 gram of tissue. The highest SAR value for this mobile phone tested is 0.502 W/kg for the head and 0.742 W/kg at 10mm from the body.

Declaration of Conformity

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Operating Environment and Usage

• Use the smartphone in an environment with a temperature between -10°C to +45°C (+14°F to +113°F).
• Use the earpiece with care. Excessive sound pressure from headphones may cause hearing loss.
• The product shall only be connected to a USB interface of USB2.0 version.

Manufacturer Information

Manufacturer: Foxx Development Inc.

Address: 3480 Preston Ridge Road, Suite 500, Alpharetta, GA 30005

Battery Manufacturer: Shenzhen Aerospace Electronic Co., Ltd.

Battery Manufacturer Address: 4th Floor, No. 42 Langkou Industrial Park, Langkou Community, Dalang Street, Longhua New District, Shenzhen

WEEE Recycling

This product should not be treated as household waste. Instead, it should be delivered to the appropriate collection point for the recycling of electrical and electronic equipment.

Frequency Bands

GSM Operating Frequency:

• GSM 850: TX: 824-849MHz; RX: 869-894MHz
• PCS 1900: TX: 1850-1910MHz; RX: 1930-1990MHz

WCDMA Operating Frequency:

• Band 2: TX: 1850-1910MHz; RX: 1930-1990MHz
• Band 4: TX: 1710-1755MHz; RX: 2110-2155MHz
• Band 5: TX: 824-849MHz; RX: 869-894MHz

LTE Operating Frequency:

• Band 2: TX: 1850-1910MHz; RX: 1930-1990MHz
• Band 4: TX: 1710-1755MHz; RX: 2110-2155MHz
• Band 5: TX: 824-849MHz; RX: 869-894MHz
• Band 12: TX: 698-716MHz; RX: 728-746MHz
• Band 17: TX: 704-716MHz; RX: 734-746MHz
• Band 41: TDD: 2496-2690MHz
• Band 66: TX: 1710-1780MHz; RX: 2110-2200MHz
• Band 71: TX: 663-698MHz; RX: 617-652MHz

FM Operating Frequency: 87.5MHz - 108MHz

GPS/GLONASS Operating Frequency: L1: 1559MHz~1610MHz, R1: 1559MHz~1610MHz

Legal and Compliance

Google is a trademark of Google LLC.

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.