Conde SDS 6 Power Pak

Gasoline Powered Vacuum Units

Conde PowerPak gasoline-powered vacuum pump units are compact and available with either Conde vacuum/pressure or vacuum only pumps. Electric or pull start Honda engines can be specified. Standard with v-belt drive with beautiful diamond plate belt guard and trim. Conde PowerPak units are ready to quickly install on your system for your vacuum needs. Quality, reliability, and ease of operation!

A photograph shows a Conde SDS 6 Power Pak unit. It features a red and silver Honda GX870 gasoline engine connected via a v-belt drive to a silver Conde vacuum pump. The assembly is mounted on a sturdy skid with a diamond plate finish, including a diamond plate guard over the v-belt. The unit is designed for industrial vacuum applications.

Conde SDS 6 Vacuum Pump Features

115 CFM Free Air.
Double Shaft Design.
O-Ring Seals Prevent Leakage.
Automatic Oiling, No Adjustment.
Low Profile, Mounts Where Others Can't.
Sealed Bearings Require No Maintenance.
End Thrust Protection.
Tangential Rotor Design For Longer Vane Life.
ONE YEAR WARRANTY

Honda OHV Gasoline Engines Features

OHV Head Design.
Cast Iron Sleeve Cylinder.
Ball Bearing Crankshaft.
Automatic Oil Alert System Shuts Motor Down When Oil Is Low.
Low Vibration & Noise.
Low Maintenance.
Easy Starting.
Two Year Manufacturer's Warranty.

Dimensional Specifications

Note: Add 5 inches (12.7 cm) to the overall length when the slide valve handle is pulled out (vacuum position).

Dimensional specifications are provided for the Conde SDS 6 Power Pak unit. The overall length is shown as 32-1/2 inches (82.55 cm), with a base length of 27-1/2 inches (69.85 cm). The width is 19 inches (48.26 cm) and the height is 18 inches (45.72 cm). A note indicates that an additional 5 inches (12.7 cm) should be added to the overall length when the slide valve handle is pulled out into the vacuum position. The pump unit itself measures 21-1/2 inches (54.61 cm) in length.

Technical Specifications

Specification	Part No. OLUN06SDS09ES	Part No. HDUN06SDS09ES
CFM, FREE AIR	115	115
CFM, 15" Hg	55	55
Horsepower	9.0	9.0
Honda El. Start	YES	YES
Vacuum/Pressure	NO	YES
Vacuum Only	YES	NO
Maximum Vacuum	27" Hg	27" Hg
Maximum Pressure*	15 PSIG	15 PSIG
Weight	195 Lbs.	200 Lbs.
Oiler	Automatic	Automatic

*Conde Pumps recommends that pressures on tank systems do not exceed 10 psi. Unit pressure relief vents are set at 5 to 10 psig. Pressure vents will relief tank pressure when unit is shut off. For higher pressures consult factory.

Performance Specifications

Tank Pull Down Time to 15" Hg

TANK SIZE	SDS 6, 9.0 HP
500 gallons	23 sec.
750 gallons	35 sec.
1000 gallons	47 sec.
1500 gallons	70 sec.
2000 gallons	93 sec.

Contact Information

Conde' Pumps
Westmoor Ltd.
906 West Hamiltion Avenue
P.O. Box 99
Sherrill, New York 13461

Phone: 800-367-0972, 315-363-1500
Fax: 315-363-0193
E-Mail: pumps@westmoorltd.com

	Conde Super 6 Vacuum Pump: Specifications and Performance Data Detailed specifications, dimensional data, and performance metrics for the Conde Super 6 Vacuum Pump, featuring a 70 CFM capacity and double shaft design. Information provided by Westmoor LTD.
	Quick Installation Guide: Sawgrass SG500 & SG1000 Sublimation Printers Step-by-step instructions for installing Sawgrass SG500 and SG1000 sublimation printers from Condé, covering unpacking, setup, ink installation, and important connection guidelines.
	Condé Sawgrass Virtuoso SG500/1000 Quick Setup Guide Comprehensive guide to setting up the Condé Sawgrass Virtuoso SG500 and SG1000 sublimation printers, covering unpacking, accessory installation, ink loading, paper handling, and computer connection.