123LED Ceiling Lamp with Motion and Night Sensor

Product Overview

This document provides instructions for the installation, operation, cleaning, maintenance, and disposal of the 123LED ceiling lamp with integrated motion and night sensor. Please read all instructions carefully before proceeding.

Dimensions: Diameter: 300 mm, Height: 62 mm

Features:

• Adjustable wattage (8W, 11W, 16W)
• Adjustable color temperature (3000K, 4000K, 6000K)
• PIR motion sensor with adjustable time and sensitivity settings
• Night sensor with adjustable lux level

Installation Instructions

Important Safety Information:

• Ensure the power is switched OFF before installation.
• Installation must be performed by a qualified electrician.
• Do not look directly at the light source as it can cause eye damage.
• Ensure adequate ventilation during use.
• Keep out of reach of children and animals.

Step-by-step installation:

1. Turn off the power supply.
2. Mount the base to the ceiling or wall using the provided screws and wall plugs.
3. Connect the wires according to the wiring diagram (refer to image).
4. Attach the lamp to the base.
5. Install the CCT-switch and Power-select settings as desired.
6. Install the PIR and Night Sensor settings as desired.
7. Turn the power supply back on.

Note: The warranty will be void if the device is opened in any way other than described.

Settings and Adjustments

CCT-switch: Select the desired light color (3000K, 4000K, or 6000K).

Power-select: Choose the desired wattage (8W, 11W, or 16W).

PIR Sensor:

• Time: Adjust the duration the light stays on after motion is detected (5 sec, 1 min, 5 min, 10 min).
• Sensitivity: Adjust the detection range of the motion sensor.

Night Sensor:

• Lux: Set the light level at which the motion sensor activates (e.g., <10 LUX, >10 LUX).

Product Specifications

• IP Rating: IP54 (protected against solid objects > 1mm and water splashing from all directions)
• Light Source: Non-replaceable LED
• Control Gear: Non-replaceable
• Color Rendering Index (CRI): Ra 80
• Operating Temperature: [Specify temperature range if available]
• Beam Angle: [Specify beam angle if available]
• Lifetime: [Specify lifetime in hours if available]
• Total Lumens: [Specify total lumens if available]

Warranty and Service

123LED offers a 24-month warranty on this product, provided it has been used, installed, and maintained as intended. For full warranty terms and further information, please visit www.123led.nl or contact customer service.

Cleaning and Maintenance

• Do not use detergents or abrasive cleaners.
• Do not clean the inside of the device.
• Repairs should only be performed by qualified personnel.
• Clean the exterior with a soft, damp cloth.

Disposal Instructions

This product should be disposed of separately from household waste. It must be submitted for recycling in accordance with local environmental regulations. Do not dispose of in landfills or incinerators. By separating and recycling electronic waste, you contribute to protecting the environment.

Replaceable batteries and lamps must be removed and disposed of separately.