Commercial Foodservice & Kitchen Equipment | Vollrath Foodservice
Installation Guide for VOLLRATH models including: T39731A, T39731A One Piece Cafeteria Breath Guard, T39731A Cafeteria Breath Guard, One Piece Cafeteria Breath Guard, Cafeteria Breath Guard, Cafeteria Guard, Breath Guard
Vollrath T39731A Parts & Manuals | Parts Town Canada
Vollrath T39731A Refacciones y Manuales | Parts Town México
File Info : application/pdf, 2 Pages, 788.18KB
DocumentDocumentInstallation Instructions One Piece cafeteria Breath Guard three Piece cafeteria Breath Guard These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard. One Piece Breath Guard installatiOn Some units are shipped with a breath guard not installed. To install the breath guard follow these steps: NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack. 1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights. three Piece Breath Guard installatiOn Some units are shipped with a breath guard not installed. To install the breath guard follow these steps: NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack. 1. Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights. c i a c f e c h c e G e a c e f a a B c B G c Bd c a Figure 1. One Piece Breath Guard Installation 2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side. 3. Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations. 4. Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side. a c c a a B G c B c Bd Figure 2. Three Piece Breath Guard Installation 2. Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side. 3. Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations. 4. Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side. 5. Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations. 6. Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations. Item No. 2350030-01 Rev 04/12 www.vollrathco.com The Vollrath Company, L.L.C. 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A. Main Tel: 800.628.0830 Service Tel: 800.628.0832 FAX: 800.752.5620 Vollrath of Canada, Co. Tel: 800.695.8560 FAX: 800.752.5620 © 2010 The Vollrath Company, L.L.C.