Remo Audio 4 User Manual
Assembly Drawing
The assembly drawing illustrates the connection of various components. Key elements include numbered parts (e.g., 2A, 4, 6) and color-coded wires (black, white, red) with specified lengths in millimeters (e.g., 100, 1000, 2200). The drawing also indicates connectors, a main unit with the brand name "Remo Audio", and a protective sleeve for a plug.
Instructions
- Connect the product according to the assembly drawing.
- When powered on, the device enters pairing mode with an audible prompt.
- Enable Bluetooth on your phone, search for "Remo Audio 4", and pair the device. A prompt tone confirms successful pairing.
- Open music tracks on your phone. Music controls such as pause/play, volume up/down, previous track, and next track can be managed from your phone.
- Disconnect the Bluetooth connection from your phone; a prompt tone will sound.
Remark: Bluetooth has a reconnection function.
Product Parameters
| Parameter | Value |
|---|---|
| Power Input | DC12V 2A |
| Speaker Output | 8W x 2 |
Common Troubleshooting
| Fault | Possible Causes and Solutions |
|---|---|
| Unable to power on | 1. No power connection. 2. Wire is disconnected or plug is not fully inserted. 3. The connected socket is faulty. |
| No sound | 1. The extension cable of the speaker is disconnected. Please check all connections or reconnect them. |
| Bluetooth cannot connect | 1. Device is already connected to other Bluetooth devices. Power off and then power on again to search for Bluetooth pairing. 2. Device is beyond the effective range (please do not connect beyond 8 meters). Avoid connecting through obstacles. |
| Music is played by another device | 1. As Bluetooth has a back-connection function, check if the phone is paired with two Bluetooth devices simultaneously. Cancel the pairing of one device and click the play button on the phone. |
Compliance Information
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
