Product Overview
Brand: CRAZON
Product Name: STUNT LIGHT DRIFTING CAR
Age Recommendation: Ages 3+
Features: Colorful light, Can swing from side to side, Energy drift.
Colors and contents may vary from illustration.
Battery Installation
Please place the wires as shown in the drawing.
Car Battery Installation:
1. Open the battery cover of the R/C car. Install the 7.4V 500MAH rechargeable battery pack. Fasten the cover. Turn the [Power Switch] to 'ON'.
Diagram Description: Shows the car chassis with the battery compartment, the 7.4V 500MAH battery pack, and the ON/OFF and Lighting switches.
Transmitter Battery Installation:
2. Open the battery cover of the transmitter. Install 2x1.5V "AA" batteries. Fasten the cover. Turn the [Power Switch] to 'ON'.
Diagram Description: Shows the remote control with its battery compartment for 2x1.5V "AA" batteries.
Origin: MADE IN CHINA
Basic Operation
Follow these steps for basic operation:
- Please turn on the switch in the chassis and then make decoding to start the car.
- Push or pull the trigger of the transmitter to make the car go forward or backward. [Forward/Backward Control]
- Turning the transmitter's steering wheel clockwise causes the car to lean right and turn right. [Steering Control]
- Turning the transmitter's steering wheel counter-clockwise causes the car to lean left and turn left. [Steering Control]
Press the switch, and the colored lights come on. There are seven modes of change.
Diagram Description: A sequence of four images showing the car and remote control for forward/backward movement and turning left/right. Another image shows the colored lights activating.
Charging and Specifications
- Charge by USB: About 2.5 hours.
- Playing Time: About 25 Mins.
- Control Distance: About 25M.
- Battery Capacity and Voltage: 500MAH, 7.4V.
- Frequency Bands: 2405MHz-2475MHz.
- Max Output Power: -1.88dBm(0.65mW).
BATTERY SAFETY
Please follow these safety guidelines:
- The placement or replacement of batteries is to be performed by an adult.
- Remove the rechargeable battery from the chassis before charging.
- Always remove exhausted batteries from the car and the transmitter.
- Make sure the main switch is set to OFF before installing the battery pack into the car body.
- Batteries must be inserted with the correct polarity.
- Non-chargeable batteries shall not be recharged.
- Do not short-circuit the batteries.
- Always remove the batteries from the car and the transmitter after playing.
- Never throw the batteries into fire to avoid explosion or leakage.
- Do not mix batteries from different producers or new and old batteries.
- You should only use batteries of the same or equivalent types as recommended.
- Check the batteries on a regular basis to avoid leakage.
- Keep this manual well for future reference as it contains important information about this product.
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. [FCC Certified]
[Recycle Symbol] PLEASE RECYCLE
