Milwaukee M12™ Undercarriage Light
Cat. No.: M12 UCL
IMPORTANT SAFETY INSTRUCTIONS
WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. When using electric appliances, basic precautions should always be followed, including the following:
- Before using, read this operator's manual, your battery pack and charger operator's manual, and all labels on the battery pack, charger and light. Learn your light's applications and limitations as well as potential hazards associated with this type of tool.
- Read and understand all the instructions before using the appliance.
- To reduce the risk of injury, close supervision is necessary when an appliance is used near children.
- Store idle light out of reach of children. Warm lights can become hazardous in the hands of children.
- Do not store light by the magnetic storage tray.
- Remove light from undercarriage before operating a vehicle. A light left attached to the undercarriage may break free which could result in personal injury.
- Store indoors. Do not expose to rain.
- Batteries must be recharged only with the charger specified by the manufacturer. A charger that may be suitable for one type of battery may create a risk of fire when used with another battery.
- Use light only with specifically designated battery pack. Use of any other batteries may create a risk of fire.
- When battery pack is not in use, keep it away from metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns, or a fire.
- Maintain labels and nameplates. These carry important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement.
SAVE THESE INSTRUCTIONS
ADDITIONAL BATTERY SAFETY RULES
WARNING: To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack or charger in fluid or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach-containing products, etc., can cause a short circuit.
WARNING: Do not charge non-rechargeable batteries. ?
SYMBOLOGY
Symbol/Term | Meaning |
---|---|
V | Volts |
DC | Direct Current |
? | Read Operator's Manual |
? | Magnet |
? | Pinch Hazard - Keep hands out of pinch zone |
⚡ | Class III protection |
?️ | Do not stare at light source. |
The product was only suitable for indoor use. Never expose the product to rain. ?️
Regulatory Compliance Mark (RCM). This product meets applicable regulatory requirements. ♻️
Do not dispose of electric tools together with household waste material. Electric tools and electronic equipment that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility.
FUNCTIONAL DESCRIPTION
Diagram shows a numbered illustration of the Milwaukee M12™ Undercarriage Light. Key components are labeled:
- Fuel gauge
- Mode button
- Power button
- Light head
- Light head handle
- Magnetic storage tray
- Magnetic base
- Battery bay
SPECIFICATIONS
Specification | Details |
---|---|
Cat. No. | M12 UCL |
Light Output | |
High | 1,200 Lumens |
Medium | 800 Lumens |
Low | 600 Lumens |
Battery Type | M12™ |
Charger Type | M12™ |
DC Input Volts | 12V |
Max DC Input Amps | 0.8A |
Recommended Ambient Operating Temperature | -17°C to 51°C |
ASSEMBLY
Inserting/Removing the Battery
WARNING: Recharge only with the charger specified for the battery. For specific charging instructions, read the operator's manual supplied with your charger and battery.
- To remove the battery: push in the release buttons and pull the battery pack away from the tool.
- WARNING: Always remove the battery pack any time the tool is not in use.
- To insert the battery: slide the pack into the body of the tool. Make sure it latches securely into place.
Illustration depicts the process of inserting and removing the battery pack from the tool. Arrows show pushing release buttons to remove and sliding the pack into the bay to insert.
OPERATION
WARNING: To reduce the risk of injury, do not look directly into the light when the light is on. ?️
- To turn on the light: press the [power button].
- Press the [mode button] to cycle through High, Medium, and Low settings.
- To turn off the light: press the [power button] again.
- Use the magnetic storage [magnetic storage tray] to store nuts and bolts.
WARNING: The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. ?️
CLEANING
Keep tool handles clean, dry and free of oil or grease. Use only mild soap and a damp cloth to clean the tool, battery pack and charger since certain cleaning agents and solvents are harmful to plastics and other insulated parts. Some of these include gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia and household detergents containing ammonia. Never use flammable or combustible solvents around tools. ?
MAINTENANCE
WARNING: To reduce the risk of injury, always unplug the charger ? and remove the battery pack ? from the charger or tool before performing any maintenance. Never disassemble the tool, battery pack or charger. Contact a MILWAUKEE® service facility for ALL repairs. ?
Maintain Light
Keep your light, battery pack and charger in good repair by adopting a regular maintenance program. If the light does not work properly, return the light to a MILWAUKEE® service facility for repairs.
ACCESSORIES
WARNING: Use only recommended accessories. Others may be hazardous. ⚠️
For a complete listing of accessories, go online to www.milwaukeetool.com.au / www.milwaukeetool.co.nz or contact a distributor.
WARRANTY - AUSTRALIA and NEW ZEALAND
Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold by authorised dealers in Australia and New Zealand.
SERVICE - AUSTRALIA and NEW ZEALAND
MILWAUKEE® prides itself in producing a premium quality product that is Nothing But Heavy Duty™™. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
For a list of MILWAUKEE® dealers, guarantee or service agents please contact MILWAUKEE® Customer Service or visit our website.
- Australia Toll Free Telephone Number: 1300 645 928
- New Zealand Toll Free Telephone Number: 0800 645 928
Or visit: www.milwaukeetool.com.au / www.milwaukeetool.co.nz.
Company Information
Milwaukee Electric Tool Corporation
13135 West Lisbon Road, Brookfield, Wisconsin U.S.A. 53005
Milwaukee Tool (Australia)
21 Kelletts Road, Rowville, VIC 3178
Melbourne, Australia
Milwaukee Tool (New Zealand)
274 Church Street, Penrose,
Auckland, 1061, New Zealand
DESIGNED BY MILWAUKEE ELECTRIC TOOL CORP. PROFESSIONALLY MADE IN CHINA PRINTED IN CHINA