JBL EON 600 Technical Support Guide

STEP 1 - MASTER RESET

To prepare your JBL EON 600 speaker for pairing:

• Ensure the unit is powered off.
• Press and hold both the BOOT and EQ+ buttons simultaneously.
• While holding these buttons, turn the unit on.
• Continue holding the buttons until all LEDs on the unit begin to flash.
• The LEDs will flash a total of 5 times, after which the unit will power cycle.

After the reset, press the SYNC button to broadcast the Bluetooth address, making the speaker discoverable.

[Description of image: Speaker control panel showing BOOT and EQ+ buttons highlighted, and the SYNC button.]

STEP 2 - EON CONNECT APP

This section guides you through connecting your speaker using the JBL EON Connect app.

Android Setup

On the EON Connect App:

• Press the [add button] (represented by a '+') to add a new speaker.
• You will see up to four circles, each labeled [OPEN], indicating available speaker slots.

[Description of image: EON Connect app interface showing four '[OPEN]' slots and the '+' button.]

Press the Scan button to locate your JBL EON speaker.

[Description of image: EON Connect app interface showing the 'Scan' button.]

Select the discovered device from the list. The example shows an EON612.

[Description of image: EON Connect app interface showing a list of discovered speakers, with one selected, identified as 'EON612'.]

iOS Setup

Press the Scan button to locate your JBL EON speaker.

[Description of image: EON Connect app interface on iOS showing the 'Scan' button.]

Select the discovered device from the list. The example shows an EON612.

[Description of image: EON Connect app interface on iOS showing a list of discovered speakers, with one selected, identified as 'EON612'.]

The app will then sync the EON speaker to the next available slot.

[Description of image: EON Connect app interface showing a speaker syncing.]

Connection Confirmation and Control

Once connected, the device will show as Online in the app.

Success!

[Description of image: EON Connect app showing a speaker listed as 'Online'.]

Double-tap on the connected speaker in the app to control its settings, such as Volume, EQ, and Speaker Delay.

[Description of image: EON Connect app control interface showing Volume slider, EQ options, and Speaker Delay settings.]