User Guide for EasyGates models including: K1, Outdoor Easy Keypad, K1 Outdoor Easy Keypad, Easy Keypad, Keypad

K1 Quick Set Up

Download

AK1 Outdoor Easy Keypad Quick Setup Guide - EasyGates Manuals

K1 Quick Set Up Door release - code must be typed from standby mode followed by # Deleting User Code 1. Enter programming mode.

• Google Docs
• Google Drive
• Download [pdf]



File Info : application/pdf, 1 Pages, 195.68KB

Document Document

K1 Quick Set Up
Programming Mode 1. Power on, red LED illuminates. 2. Type  Master code # (Default code 123456). Green LED illuminates for 0.5 secs to show accepted. 3. LED begins to flash red to programming mode is active
Changing Master Code 1. Enter programming mode 2. Press 0, LED illuminates orange constantly. 3. Enter new code followed by #. Green LED illuminates for 0.5 secs to show accepted. LED illuminates orange constantly. 4. Repeat new code followed by #. . LED illuminates green for 0.5 secs to show accepted. LED illuminates orange constantly. 5. 6. LED begins to flash red to programming mode is active 7. Type  to exit programming mode
Adding User Code 1. Enter programming mode 8. Press 1, LED illuminates orange constantly. 2. Enter USER ID 0-989 followed by #. Green LED illuminates for 0.5 secs to show accepted. LED illuminates orange constantly 3. Type new code followed by #. LED illuminates green for 0.5 secs to show accepted. LED illuminates orange constantly 4. Press # again. LED illuminates green for 0.5 secs to show accepted. 5. LED begins to flash red to programming mode is active 6. Type  to exit programming mode
Door release - code must be typed from standby mode followed by #
Change Relay Time 1. Enter programming mode. 2. Press 4, orange LED illuminates constantly. 3. Type value 1-99. Default is 5 seconds. (1=50ms. 0=Latching/Toggle.) 4. Press #, Green LED illuminates for 0.5 secs to show accepted. 5. LED begins to flash red to programming mode is active.
Deleting User Code 1. Enter programming mode. 2. Press 2, orange LED illuminates constantly. 3. Enter User ID, press #. Green LED illuminates for 0.5 secs to show accepted. 4. Press # again. 5. LED begins to flash red to programming mode is active.
Restore Factory Settings 1. Remove power from the keypad 2. Press and hold  power on the keypad 3. The sounder will beep twice. Release the  and the sounder will beep again.
No user codes will be erased. Only the master code and settings will be reset.