User Manual for Angekis models including: U2-10FHD3, U2-10FHD3 Camera Web Magazine, Camera Web Magazine, Web Magazine, Magazine
Blade VS —9— Menu Key OK:toconfirmthemenuselection Menu：enter/exitmenu Back：Backtopreviousmenu F /F-: Setfocusbymanual,onlyvalidundermanualfocus
Blade VS
User Manual v2.0 EN
1/2.8 inch, 5MP CMOS
1/2.8 inch, 5MP CMOS RS232, RS485 (Serial VISCA, Pelco-P/D), USB2.0 (UVC1.1)
IR REMOTE CONTROLLER
Blade VS
Power Key Under Normal working mode short press Power key to let the camera enter standby modePress it again the camera will do self-configuration and then go back to HOME positionIt will go to preset position if the power on mode has been set.
Address/Camera Setting Key Set+Cam1-Cam4set camera's remote Control address. Short press Cam1 - Cam4 to select the camera.
Number Key Set Presets: Set+(0-9) number key to recall presets Clear Key Clear +(0-9): to clear the relative preset; Long press to clear all presets.
--8--
Blade VS
Menu Key OK: to confirm the menu selection Menuenter/exit menu BackBack to previous menu
F+/F-: Set focus by manual, only valid under manual focus mode. T/W: Set the lens zoom rate Navigating Key:Up/Down/Left/Right Under normal working mode, use navigate key to set the pan tilt, and select values when enter OSD. Home Key: Under normal working mode, short press Home key to let the camera go back to home position.
Flip: Enable/Disable the picture up/down flip Mir: Enable/Disable the picture left/right flip MF: Enable manual focus mode AF:Enable auto focus mode
SHARP: Set sharpness level NR+/-: Set noise reduction level Reset: Long Press(3Sto reset camera REV: Display camera revision
--9--
CorelDRAW 2021 Corel PDF Engine Version 23.1.0.389